if I could make that on my cnc it would make my day
@annahuang9243
7 жыл бұрын
WOW, great job
@tnkgunnerh66
5 жыл бұрын
Does F-engrave support bit changes or did you manually have to create each tool path for each bit?
@Olivsam
4 жыл бұрын
I use f engrave but am new to cnc. Do you have to reset your x y and z when you do the tool change? Then you just run the new g code?
@mannoc
4 жыл бұрын
yes. if using bobs cnc there is an attachment you can find on the internet that allows you to change the bit without re zeroing. support.bobscnc.com/hc/en-us/community/posts/360026815153-Bit-changer-kit
@joelvanstaden9083
7 жыл бұрын
Looks good. Why did you use cooking oil
@Cravtec
7 жыл бұрын
To preserve wood and better visual effect, color is more saturated.
@mattpiehl7122
8 жыл бұрын
where did you get the image I would love to get it
@Cravtec
8 жыл бұрын
Found in the internet and modified by myself. Can send you this pic or g-code. Send me an email on crevtec.com or write message by facebook.
@unclebob8746
5 жыл бұрын
Nice job. Music is to loud.
@Multimen76
6 жыл бұрын
:) frezy kupujesz od Bit-tech ?
@mmi2805
6 жыл бұрын
Paweł Dubiel Dokładnie tak :)
@Multimen76
6 жыл бұрын
mateuszmmi no tak mi sie zdawalo ;) ze to 2 piura z weglika z powloka do ciecia alum na sucho i v-bit 6mm z weglika nawiertak polerowany fajny ostry frez do drewna idealny rozne rzeczy ludzie sprzedaja ale Bit-tech ma dobrej jakosci narzedzia czeskie gwintowniki lepsze niz nasze a frez do alum sie sprawdza mimo ze uzywalem na lekkim cnc na paskach ;)
Пікірлер: 14