Don't forget the crush gaskets and other stuff you need to DIY your oil change! OIL FILTER FOR K1600: amzn.to/3opG4YS CRUSH GASKETS FOR OIL PLUG: amzn.to/3OEap0Q MAHLE OIL FILTER WRENCH: amzn.to/3orPtiY LOW PROFILE SOCKET FOR MAHLE WRENCH: amzn.to/3OAZ69j (This works great with the Mahle filter wrench!) CASTROL MOTORCYCLE OIL: amzn.to/3onnn8t ADJUSTABLE OIL DRAIN PAN: amzn.to/3sTFYeR
@chrisbenjamin2642
3 жыл бұрын
Since we're using lumber, I'll say you hit the nail on the head here. I have fought this GL1500 for two weeks and got it on the center stand once. I backed it up onto a 1/2" piece of plywood and BAM - up she went just like the GL1100 I used to have. Excellent video. If you're short like me (5'5"), crank the rear shock air pressure up to 50 psi or so, get a chunk of plywood, and let her rip!
@californiahikebike
3 жыл бұрын
Hey Chris thanks for the comments. You might want to check this one out that I did with my buddy who is 5'6". It's a little more in depth. kzitem.info/news/bejne/l2uj3GiVqZd9rX4
@chrisbenjamin2642
3 жыл бұрын
@@californiahikebike Thanks!
@adancaicedo3217
3 жыл бұрын
Excellent, thank you for your great idea.
@californiahikebike
3 жыл бұрын
You're welcome!
@marcroix1
2 жыл бұрын
Gracias por compartir, tu técnica esta increíble!!
@californiahikebike
2 жыл бұрын
De nada mi amigo!
@phillipdavies6535
3 жыл бұрын
I cut a ramp out of a 40 mm Plank about 18 Inc long, with a stop did so the bike would not go off other side, made lifting easey
@californiahikebike
3 жыл бұрын
Sounds like a good setup!
@timbarnett3898
3 жыл бұрын
I use this because I don't have concrete pad yet. So I put plywood pieces under side stand, center stand an rear tire. From side stand to center stand then up on center stand with help of pad under rear tire! If lumber & building material prizes come down, I'll complete concrete motorcycle pad, an bike enclosed!
@uwes8928
2 жыл бұрын
There is a need little trick on the RT, GS and K1600 Bikes, well first take your luggages off makes the bike lighter, then if you have ESA put it in full 2 ppl full luggage mode and you will feel the bike rising up after that it's so easy to put the bike up.
@californiahikebike
2 жыл бұрын
Yes sir! I mentioned 2 up mode if not on this video I did mention on the main video I believe. Thanks for the tip! kzitem.info/news/bejne/q2mqunWMbaBedY4
@dalejones6627
Жыл бұрын
I use a rubberized outdoor tile 1/2x 12”x12” available at big box garden section. One under each tire. I have a Gold Wing and suffer with foot pain. Just one thing to extend my riding days.
@californiahikebike
Жыл бұрын
That sounds like a great idea!
@kevinjersey1619
2 жыл бұрын
Honda Gold Wing allows a "Ride-Off" center stand to replace the regular one. It is actually a cut down version of the regular one. You can also put bike in reverse and back it onto the stand.
@californiahikebike
2 жыл бұрын
The stock Gold Wing is a lot easier to center stand than the BMW for whatever reason. Check this one out that features both: kzitem.info/news/bejne/l2uj3GiVqZd9rX4
@fuzzy883
2 жыл бұрын
I have a Honda st1300 and with full fuel tank I could put all my weight on the center stand with no hope of having it go up. I have to use my full weight and pull back on the side handle all in one strong motion. I recently serviced my rear shock and stiffened it up.... Now it's even harder to get up haha.
@californiahikebike
2 жыл бұрын
Man there are a lot of inuendos in that comment! 🤣🤣😂
@fuzzy883
2 жыл бұрын
That's what she said :(
@californiahikebike
2 жыл бұрын
@@fuzzy883 🤣🤣😂🤣
@dominicsciberras8443
3 жыл бұрын
That is a good if you have a reverse gear on your bike
@californiahikebike
3 жыл бұрын
The setup I made was pretty rudimentary knowing I was only using it for this shoot. I suppose if I needed this type of thing for myself, I would create a board setup with a small ramp on both ends so I could drive forward onto it. I'm sure there are folks out there that can do it way better than I can. This was just for demo purposes. Ride safe!
@marekryszard
Жыл бұрын
You have a reverse gear on that ?!?
@californiahikebike
Жыл бұрын
Yup! Awesome!
@nicotadina9758
3 жыл бұрын
i hope im gonna learn how to center stand my nmax motor i hope really .
@californiahikebike
3 жыл бұрын
Good Luck. Watch all three videos. You may get something from all of them to help out...
@californiahikebike
3 жыл бұрын
And before I get shredded....I didn't want to use a simple wood block for this experiment. LOL
@laryangel4082
2 жыл бұрын
9
@californiahikebike
3 жыл бұрын
This is the second of a three part series. If you are having difficulty, I encourage you to check out the other 2. 1st video - Best Center Stand Technique - kzitem.info/news/bejne/q2mqunWMbaBedY4 3rd Video - Can a 5'6" Guy Center Stand His Heavy Bike - kzitem.info/news/bejne/l2uj3GiVqZd9rX4
@kriskoppy2753
3 жыл бұрын
Seriously?
@californiahikebike
3 жыл бұрын
Yup. I was skeptical as well. Go to 7:00 of this video if you don't believe it. kzitem.info/news/bejne/l2uj3GiVqZd9rX4
Пікірлер: 32