Centurion gate motors are commonly stolen.
To prevent the theft of your Centurion gate motor, you need a expert Centurion gate motor installer. So call Pottie now on 083 778 2288 to assist with your gate motor installation.
We assisted this insurance client as his Centurion gate motor was stolen.
We always pull out all the stops, when we install any sliding, swing gate motor system.
On this site, the steel base plate was still present.
It was properly concreted into the ground, but the steel base plate was skew.
All gate motors need to be fitted parallel with the steel sliding gates and they must be fitted upright and also level. A gate motor should not lean over towards the steel sliding gate.
The steel base plate of the new Centurion D5 Evo gate motor was adjusted to accommodate the old skew base plate.
The gate motor was assembled and serial numbers burnt out onto the gate motor.
The steel anti theft bracket ears and steel bolts were welded in order to prevent unbolting of the gate motor.
extra steel plates were fitted under the anti theft bracket ears and welded down. so the only way to get this gate motor off, is by cutting it off.
With the gate motor properly fitted "proper steel welding of the gate motor is paramount in order to prevent another theft", the steel gate rail was joined and welded onto the steel sliding gate.
30x30x3mm angle brackets were used every 500 to 600mm. At times 40x40x3mm angle brackets will be used to secure the steel gate rail onto the steel sliding gate. The start up sections has extra brackets present to prevent lifting of the steel gate rail.
The gate motor origin marker was fitted onto the steel gate rail.
the gate motor limits were programmed as well as the new remote transmitters.
the gate motor was tested and found to be working properly.
one can hear on the video, that the gate motor is running smoothly and the current during the running of the steel sliding gate is constant all over.
This shows that the gate motor is properly installed as per factory specifications.
This gate motor should last the client around 15 years if all yearly maintenance is conducted correctly.
The Centurion D5 Evo sliding gate motor is a 12 volt battery operated sliding gate motor.
Thus the gate motor uses battery power to open and close the steel sliding gate.
Eskom electricity is used to charge the gate motor battery only.
The gate motor battery should be kept fully charged as a low voltage gate motor battery will cause the steel sliding gate motor system to malfunction.
We also repair, maintain, troubleshoot all Centurion sliding gate motors.
We also install, repair, maintain and troubleshoot Gemini sliding gate motors.
Gemini sliding gate motors are also good gate motors to use when automating steel sliding gates.
Check us out @:
www.exquisites...
Негізгі бет Centurion D5 Evo sliding gate motor installers, Experts Pottie 083 778 2288
No video
Пікірлер