Sir is it possible to analyze mixing of co2 gas with cold water in a pressurized vessel in solidworks. Suppose a vessel is in vertical shape( 400mm diameter × 1700mm height × 3mm thickness) and vessel is half packed with series of perforated plates and then we pressurized that vessel from co2 gas up to 5 bar which will remain constant throughout the simulation or process.Consider half inch duct for co2 gas inlet from any side of vessel and then with the help of high pressure pump, cold water(2 degree celsius, volume flow rate 4 cubic meter per hour)is sprayed through nozzles from the top of vessel towards bottom. My goal is to look out how water is passing through those perforated plates and at last how much co2 gas is mixed in water which is going to be stored in the bottom of the tank . Consider 1.5 inch duct for water inlet and 1.5 inch duct for water outlet which is open to environmental pressure. Kindly explain how to do in solidworks or in ansys. Thanks a lot 🙏.
@javiersito131
Жыл бұрын
hola muy buen contenido, disculpa estoy realizando una simulacion de un agitador tipo ancla sigo todos los pasos como los muestras pero cuando corre la simulacion para realizar los calculos me sale un warning que dice lo siguiente: unresolved volumen condition condition name: initial condition 1 . Me permite realizar la simulacion pero no se si ese warning afecte los resultados, ojala me puedas apoyar te lo agradeceria mucho saludos.
@afsalasathar2516
2 жыл бұрын
How did you solve "Create Lid" problem ?
@CFD_GUIDE
2 жыл бұрын
Dear Afsal, if the surface on which lid to be provided is not flat, you cannot provide lid normally. In that case you have to create lid manually by creating sketch and unmerged extrude boss base.
Пікірлер: 4