Thanks for the idea of turning the tool around, reversing the lathe and doing the light cuts. Just used a slight variation of this and got a nice 45 deg chamfer!
@larissapowell394
6 жыл бұрын
My god your awesome I never knew what that was for I have been making custom parts 5 so far got three more to go I was cutting my I'd to size then doing a 45 from both I'd to both od basically like a v with a flat in the middle on rod stock I was making my 45 by angling my carbide at a 45 trying to get a rough shape started and going to the I'd and jog over a quarter turn out a quarter turn till I got to I'd size then a lot of sanding u just saved me a lot of time! Thank you
@priya200328
6 жыл бұрын
Which cuting tool do you use?
@gracechege4899
4 ай бұрын
Heey somebody how do I put a chamfer on both the back and the front side
Пікірлер: 5