The simple 3 step removal and 8 step installation of a dropper post hydraulic cartridge.
In the replacement unit package you'll find the cushion, thimble, and cartridge.
Firstly, loosen the actuator, slide the cartridge out then fully remove the actuator
Loosen the rod screw allowing you to unscrew the cartridge then slide it out all the way
Grease the thimble, then insert the flattened end of the thimble into the cartridge
The thimble’s rounded end should protrude; not the flat end.
Slide the cushion into position, and then the cartridge
Screw the rod into the top of the post shaft, then lock it into position
Replace the actuator
Slide the unit into the dropper post shaft
Then tighten the actuator into position
Негізгі бет Changing a Dropper Post Hydraulic Cartridge (Remove & Install)
Пікірлер