Now I know how to change the belt thank you for the video.
@queenofdahouse1
10 жыл бұрын
great video, very easy to watch and understand.....keep making more videos !!
@chibigonmx
8 жыл бұрын
Hello, is possible to get the tool. Where can I buy the tool? thanks.
@xtrememakariatvutvlima6086
8 жыл бұрын
good video
@keepinghealthy3332
Жыл бұрын
After you put the belt back on, how do you release the clutch?
@Nicksterzone
9 жыл бұрын
Could you elaborate on the belt construction; the way they are wound. Some people just say to put it on one way when new and when you take it off, to put it on the same way for the rest of the belt life.
@magicgamingproductio
11 жыл бұрын
First finally mod time for the rzr
@TheBobcat1998
11 жыл бұрын
hey louis did you ever check out the highlifter fourm?
@barrysulkin1301
9 жыл бұрын
Good video but there are errors. He makes it look a bit easier than it really is. Who has an automotive lift in their garage or at Glamis? When removing the cover with the wheel in place, I found it easier to remove the forward screws while lying on my stomach in FRONT of the rear tire. First of all, he says 10mm for removing those screws-WRONG-its 3/8" That's a peeve I have with Polaris, using inch and metric all over the vehicle, these guys should decide which system to use and every piece of hardware should be that system. Let's get back to the clutch cover again, it shows him using an air powered tool for removal, that's OK but not to re-install because the whole case is made of plastic, even the threads for those screws ! The mechanic should use hand tools for the whole job and beware of the plastic, don't over tighten. When removing the cover with the wheel in place, I found it easier to remove the forward screws while lying on my stomach in front of the rear tire.
@ddddevyn
11 жыл бұрын
then silicone everything, those Polarises arent too good at holding out water
Пікірлер: 11