would you mind telling me where you can purchase the textured rollers from, in the UK, please
@gaillouisejewellery1079
2 жыл бұрын
The mills usually come with a couple of basic textures but I don’t know of any uk stockists. You will have to import from overseas I’m afraid.
@waliza001
2 жыл бұрын
is this machine any good?
@gaillouisejewellery1079
2 жыл бұрын
It’s perfect for texturing but don’t try and roll too thick metal or you may damage it. If you want to mill metal I would recommend a Durston
@thegalleryofeve
Жыл бұрын
Awww!!! 😩 I’m trying to do this on mine, but that bolt on the gear located on the side of the roller that you removed “nice and easy” for me it’s just stuck, and I can’t advance to the next step! 😭 How on Earth can I loosen it up? 🥹
@gaillouisejewellery1079
Жыл бұрын
Try giving it a squirt with WD40 and a little tap with a hammer and then try tightening it slightly before loosening again. When you get it out clean it up with a wire brush, clean inside the hole with WD40 and grease it up before you put it back. Hope that helps. If you put your spanner on and tap it with a hammer you should get it moving 😁
@thegalleryofeve
Жыл бұрын
@@gaillouisejewellery1079 It helped, thank youuuuu!!! ❤️🤗😭🤗❤️
@gaillouisejewellery1079
Жыл бұрын
@@thegalleryofeve yay 😁 You’re very welcome ☺️
@Huntress6988
Жыл бұрын
Bottom roll?
@gaillouisejewellery1079
Жыл бұрын
You just remove the blocks between the two and the process is the same as the top roll. The bottom one has a longer arm on one end. Hope that helps. 😊
@Huntress6988
Жыл бұрын
@Gail Louise Jewellery it does. I did figure it out. I had to pound mine out, but I got it. It belonged to someone else before me and although it was greased I think that bottom part wasnt.
@gaillouisejewellery1079
Жыл бұрын
Yeah, I re grease every time I change them. Keeps everything smooth and easy 😊👍
Пікірлер: 12