Potential Video Idea: For You I have two Lumenier 600mw transmitters. On one, the SMA adapter was ripped off and the board was damaged beyond repair. On the other, the surface mounted micro jst plug was damaged, but the board is good. I want to try to remove the micro jst from board #1, and attached it to board #2, thereby saving myself some coinage.
@ProjectBlueFalcon
7 жыл бұрын
Great idea. No problem bud. I finally finished the Taranis series, working on the receiver and flight controller series. After I finish that I'll do a series on how to fix random things like that.
@3000gtwelder
7 жыл бұрын
I just buy both kinds of antenna's or an adapter haha. Great video though, I like the trick with adding more solder to get it to come loose, it helped me fix the broken connection on my goggles, thanks.
@ProjectBlueFalcon
7 жыл бұрын
Haha hey, that works too. Nothing wrong with working smarter not harder.
@magneto_fpv4156
7 жыл бұрын
Rest in peace JC! you will be missed!
@MFR-zk4zc
7 жыл бұрын
Magneto_FPV what the??
@emtblife8944
7 жыл бұрын
MFR 7095 he died in a motorcycle accident a few weeks ago! Such a loss!
@MFR-zk4zc
7 жыл бұрын
Yeah, I just noticed that this morning.. such a loss..
@mentuemhet
4 жыл бұрын
R.I.P.
@VytautasValaitis
7 жыл бұрын
A bit easier way is to just cut off old connector and remove remaining bits with regular iron and a bit of additional solder:).
@ProjectBlueFalcon
7 жыл бұрын
That way does work for sure. Only thing is I have a 50/50 chance of removing the signal part without removing the pad on the Vtx. This way its a sure deal of not removing the signal pad. But as long as you take your time the way you explained will work just fine.
@bongdan
6 жыл бұрын
why not change the antenna connector ? is not easier ?
@marksherman630
7 жыл бұрын
Not familiar with solder paste. Search on utube showed it being used on surface mount and heated on a "skillet", then cooled. Did you heat yours at all?
@ProjectBlueFalcon
7 жыл бұрын
Nope. Any time I use solder paste I just use a soldering iron to heat it up and it turns to a metalic just like using flux core wire. After I'm done I use flux remover in a can and brush to remove the flux.
@alexdalton7290
7 жыл бұрын
Could you do the same process with an oven if it is set high enough I don't have a hot air gun
@nicolosavegnago962
6 жыл бұрын
I've tried to change my connector, but the new one doesn't fit because the pins are to thight toghether, any advise why that happended?
@Fulltimedad90
7 жыл бұрын
was curious where you purchased your edgemount sma connector. ? Just want to make sure im getting the right size.
@glytch5
2 жыл бұрын
I just use an adapter.
@bluehawk2051
Жыл бұрын
😊
@netox187
7 жыл бұрын
Hello JC did you get my private message here on YT?
@ProjectBlueFalcon
7 жыл бұрын
Nope I haven't received a message on either channel. And welcome back bud.
@madmarty7103
7 жыл бұрын
A better way is to cut the pins off with a dremel.
Пікірлер: 22