Hi Pete, we can confirm that 45nm is the correct torque setting for the guide pins as stated in the MGF workshop manual.
@johnlang3233
2 жыл бұрын
@@RimmerBrosTV That's well over spec for a couple of short 8mm bolts. You’re confusing the torques with the torque for the caliper bracket to the hub carrier, which are M10 bolts
@milesinnz
5 жыл бұрын
all you need is a big G clamp to get brake caliper pistons retracted....
@RimmerBrosTV
5 жыл бұрын
That'll work. But of course we advise using the correct tools.
@petewilson3970
2 жыл бұрын
Are you sure the 45nm is correct for pin bolts only mg club member just tried that and it snapped like a carrot.
@RimmerBrosTV
2 жыл бұрын
Hi Pete, we can confirm that 45nm is the correct torque setting.
Пікірлер: 8