There are a hundred ways to do this. My style is install the rear seal with a block of wood between seal and hammer to prevent denting the seal. I like tightening the bearings tightly first, turning the rotor about 2 turns to press out extra grease in bearings and races, then back it off to the correct amount for the key. When installing the cap, I use a chisel or block between the cap and hammer to set the cap, so I dont strike the cap. This prevents a dented cap from rubbing a hole along the cotter pin (seen it). You did a fine job, and dont ever worry about a little slack in the bearing. Your real danger is when a shop over tightens the bearings on old grease, because they "claim" your bearings are loose during annual inspection. The rule actually allows for some free play anyway. Keep up the good work.
@131chuck
4 жыл бұрын
I just binge watched all these Camaro videos! Great job Josh. You should give some "credits" out to the guys helping you. I myself have a 1982 Z28 Indianapolis 500 pace car I am looking to restore. Haven't had a chance to do anything at all since buying it :(
@marcol7847
4 жыл бұрын
Nice iroc! I purchased a 87 5 speed and thought it was an iroc but it’s not. Just a z28. You can confirm if you have a real iroc using the RPO codes
@benkalinowski5834
4 жыл бұрын
If I sent you a used set of bbk underdrive pulleys from my 88 gta trans am tpi would you do a video and put them on It shows 8-12 rwhp gain When I did it I felt it big time More than a cat back ehx
@superchile9640
4 жыл бұрын
Love my Harbor Freight ratchet
@casper_t48h49
4 жыл бұрын
Nice 5.0 iroc z
@carreviewswithjosh8028
4 жыл бұрын
Thanks!
@JJSmith1100
5 жыл бұрын
I have been following your channel ever since you started with the Iroc. I am curious how licensing, registration and inspection for road use is done in the US. Especially with a vehicle that was of the road for a long time. In my country this will be a pain if the previous owner did not de-register the vehicle or kept the annual license up to date. If the license by us is in arrears every sent must be paid up plus a fine equal to 10% of the annual licensing fee is added for every month since the license expired. It becomes uneconomical, very quickly, to ever put a car that was in arrears for a few years back on the road.
@carreviewswithjosh8028
5 жыл бұрын
Thanks for being part of the channel, Johan! In the U.S. you just license and register like any other car. You go to the DMV and make sure to bring the title and then you license and register it. And in some places in the U.S. they don't have a inspection!
@JJSmith1100
5 жыл бұрын
@@carreviewswithjosh8028 Do they have test the vehicle has to pass? Is there fines involved if the vehicles license was not renewed yearly?
@carreviewswithjosh8028
5 жыл бұрын
@@JJSmith1100 were we are there is no inspection, but there are places in the U.S. that do have an inspection. We do not have to pay fines for not keeping registration on cars when parked or off the road.
@JJSmith1100
5 жыл бұрын
@@carreviewswithjosh8028 Ever considered making a separate channel just for episodes about the Iroc?
@carreviewswithjosh8028
5 жыл бұрын
@@JJSmith1100 I can't say that I have. Do you think I should? I would love to hear your feedback.
@keithperry8098
5 жыл бұрын
You should always bleed the brakes after you've changed the pads.
@ze4l0u53
5 жыл бұрын
First!
@nathanielwachtel4901
5 жыл бұрын
JOSH!!111!!1!!! You didn't torque those lug nuts to 110ft lbs/149.13Nm1!!11!! Be careful Buddy!
@carreviewswithjosh8028
5 жыл бұрын
Oh, we did it off camera! Good observation though.
@sc3ku
2 жыл бұрын
No that is too tight!! If anyone sees this, the spec is 81 lb ft (110Nm). This is per my '88 Camaro service manual for 16" wheels. Be prepared to risk warping a wheel or breaking lug studs at 110lb ft.
@26savage69
5 жыл бұрын
Are you ever thinking of repainting the car
@carreviewswithjosh8028
5 жыл бұрын
Maybe, but it would be until next summer if we were. And we would need to fix the rust problem.
@benkalinowski5834
4 жыл бұрын
Do you want a free 19lb brake proprting spring upgrade Watch a video called 3rd gen cheapest brake upgrade And I did it to my car and I got 5 springs in the pack And I'll send them to you for free You just need to do a video my car used to nose dive really bad when I hammered the brakes and my rear disc the pads in 33 years only got changed 1 time So this is something that takes 15 mins
@carreviewswithjosh8028
4 жыл бұрын
That is very kind of you! I would take it but unfortunately I don't have a PO box. But thank you anyways! P.S.- I hope to start posting videos again soon.
@benkalinowski5834
4 жыл бұрын
@@carreviewswithjosh8028 it's ok there cheap on eBay or Amazon And cool I love 3rd gens
Пікірлер: 26