This time on the channel, I tackle changing the front wheel hubs on my 2011 GLX MN Mitsubishi triton but as you will see, it wasn't a straight bolt in process. Sit back & enjoy
▪
Timestamps for each section of the video
0:00 - Gettin dirty 4x4 adventure intro
1:32 - Positioning the 4wd with jack stands etc
2:12 - Undoing the CV bolt in the hub
3:31 - Undo the CV bolt before you start
4:10 - Undoing the break calliper
4:43 - Remove brake rotor shield
5:12 - Remove the ABS sensor
5:18 - Remove ABS sensor ring cover
5:31 - What bolts to remove next
6:09 - Things didn't go to plan..
6:13 - Explaining the issues I had
6:32 - Gettin dirty 4x4 adventure end clip
▪
This is a demonstration on how I modified and worked on my 2009-15 MN series Mitsubishi triton. I will NOT be held accountable for any damages you may/can cause following these steps. if you DO NOT know what you are doing, Take it to a qualified mechanic/workshop and have them do it for you.
▪
Video was shot with:
Gopro 8
▪
Be sure to like & subscribe to our KZitem channel for all upcoming videos👍
▪
▪
Song featured in the video
Sport Rock & Workout - Infraction
▪
📷 Instagram:
gettin_dirty_4x4_adventure
🎥 KZitem:
Gettin Dirty 4x4 Adventure
Негізгі бет Changing wheel bearings on a MN & ML triton - [ DIY ]
Пікірлер: 4