Another question please. I am not getting the right kOhm values but if I check for continuity I am getting the voltage to correspond to the table. Is it wrong?
@mercedeske
Ай бұрын
Which resistance doesn't correspond to the table?
@adanthedriver1982
Ай бұрын
@@mercedeske for e.g. at room temperature (between 20 and 30C) I am getting 4.4 kOhm but If I measure for continuity I get about 2.2V on multimeter screen and that confuses me a lot. Bought new Mahle Original sensor (Blue one with 2pins) and it's happening the same. kOhm out of range at room temp but on continuity 2.2V. So the number corresponds to the table but not the measurement unit and that melts my brain.
@adanthedriver1982
Ай бұрын
How do you measure the 1-pin sensor?
@mercedeske
Ай бұрын
The same way. The positive of the multimeter to the sensor, the negative to the ground.
Пікірлер: 7