@pklemm1 are these the 5000k power leds? They look warm white? Do u have any videos off them close up in the headlights, thinking of using them in my lights, how are they for drl during daytime, are they bright enough to be seen? Do u have them on a controller to dim them for night time and also shut off with signals
@pklemm1
7 жыл бұрын
grant gill I never finished the retrofit since the car died. Here's the build thread I had on it though. The EXled bar was the power 5K. They are white no yellow to them. There are more pictures in the thread of them up close. Also, they are definitely bright enough for a DRL. At the moment they are the brightest strip I've seen. Although the diode dynamics HD strips might be better and brighter. I've only dealt with the Amber and it blows these away. www.hidplanet.com/forums/forum/showoff/projector-retrofits/1397184-chevy-impala-quad-retrofit
@themodifiedlife2774
7 жыл бұрын
pklemm1 thanks man for the link ya I'm on hidplanet just never noticed ur build, how'd u mount them to the shroud? Did u use 5mm led legs off, the metal legs? I was told they are good to use for mounting post, solder them on he strips? Did u just use 1 power and 1 ground wire hooked at the end or did u wire each led? Do u think the led boards could be painted black to blend in? Also ya I wish there was a diffuser that could be used to cover these universally
@pklemm1
7 жыл бұрын
grant gill they are mounted to the OEM bezel using silicon. I'm just using one power and on ground. If you were going to sequence the turn signal you can wire each led and use a sequential module. The led board is mostly black. The LED's are yellow for the 5K and white for the Amber. A diffuser would help hide the LED's. I looked for one that works but was never successful. At a distance they are not noticeable though so it might not to an issue.
Пікірлер: 4