Wasn’t going to attempt until I saw this video. Great camera angles. Thanks !
@3wolfspirit
3 жыл бұрын
Thank you so very much my friend for making that video. Great filming and you explained it in a very straightforward manner that helped out so much. Thanks again brother
@FixItPhillip
3 жыл бұрын
You're welcome!
@lws7467
4 жыл бұрын
Just did my 4.8l. I'm a little low on coolant until I grab some more. If the level is ridiculously low will the overflow boil after 10 min of idle run time. I just finished everything you did in the video.
@FixItPhillip
4 жыл бұрын
Make sure to fill it with coolant, turn the heater on and make sure it gets hot, thermostat opens ect.. then check the fluid again. Check your cap too and make sure the oring/seal is good
@BobbyFigliola
10 ай бұрын
Old video but its a revelant one if ya need to do the job and get to wrk tommorow.... I was asked by a young fella why I loosened bolts manually instead of all the air and cordless i have...... i answered. 'ya wanna feel out the last robot tightened the bolts/nuts...and if all else fails...... there is a torch over there"
@luissalinas5080
3 жыл бұрын
Thanks for the video you do very good job!!
@FixItPhillip
3 жыл бұрын
Thank you!
@nephewsque6751
2 жыл бұрын
Great job
@FixItPhillip
2 жыл бұрын
Thank you
@captainrex3320
3 жыл бұрын
Hey man, I’m replacing my water pump now. 05 2500 hd. I don’t have a air compressor or chisel. Only wrenchs. Can’t get the thing to break with out Turning it the other way. Any ideas how to get it to stop moving? Sorry it’s first time doing auto work. Thank you. And great video! Liked and subed
@FixItPhillip
3 жыл бұрын
If you leave the belt on and try using a pry bar one the edge and hit the pry bar with a hammer (basically a manual air chisel lol) that should work to break it free. I've dove it before. Might take a few good hits to do it. Good luck with it
@captainrex3320
3 жыл бұрын
@@FixItPhillip She’s off thank you!
@FixItPhillip
3 жыл бұрын
Good job
@ChuchoG1226
4 жыл бұрын
If there’s a water leak, would my truck make a weird sound when I just started up ? Every time I turn it on 5-10 seconds later I hear a noise and I feel like it’s because of the water leak. I really don’t know.
@FixItPhillip
4 жыл бұрын
Its possible for a water pump to make noise when failing, try wiggling the fan clutch and see if the water pump pulley is sloppy
@kerdog2002
3 жыл бұрын
Great Video. Well filmed and great explanation. I have a 2004 2500HD and need to replace pump. Truck has 200k miles and I'm a bit concerned about the 10 mm bolts being rusted/seized. Is this typically an issue and if so any tips?
@kylehalstead865
3 жыл бұрын
I’ve just replaced the water pump and put everything back! And now I’m in the stage of truck having no coolant and having to refill. Before I put coolant in should I flush it? And when I do, I just put coolant in to cold fill line and let the truck run with heater and squeeze radiator hose and fill until air and system is full?
@ConfedVet
2 жыл бұрын
My water pump came with metal gaskets, do I need sealer?
@FixItPhillip
2 жыл бұрын
Depending on how flat of a surface the engine side gets when it's cleaned/scraped off. The metal gasket should have integrated rubber gaskets where the coolant ports are. Me personally I would lightly coat the engine side and the the waterpump side coolant ports with sealer. Then bolt the water pump with gasket on
@tomclose390
3 жыл бұрын
mines leaking a bit now did replace thermostat as well?
@Dwarte007
4 жыл бұрын
how many kms did the truck have?
@FixItPhillip
4 жыл бұрын
I think it was about 130k miles
@rigomartinez1120
3 жыл бұрын
I have a 2007 classic body 4.3 is this the same....
Пікірлер: 27