Some people tend not to believe me but I can run lean of peak with my C-150 if I very tediously adjust the mixture (which I will do on cross country trips). This has very little to do with saving fuel (which is minimal) and a LOT to do with preventing fouling from excess fuel going thru the engine.
@jimczerwinski4951
9 ай бұрын
My experience as the owner of five 182’s is oil temps and pressure. I found the O-470 oil pump was just good enough when new. But as the engine wore and tolerances grew the pump failed to provide adequate oil pressure. I actually fitted the pump off a IO-520. That solved the problem. There is a little panel beating to do around the firewall indentation to accomodate the pump plus change the studs. My operations though were in a hot climate ie 30 - 40 degrees C. I agree 380 degrees F is the target temp for cylinder heads.
@agentorange153
2 ай бұрын
The way I've been taught is, ROP for best power and LOP for best range! Also, how come you talk about using cylinder temperatures and fuel flows for setting the mixture, rather than EGT???
@joshclark6101
2 ай бұрын
Why do crews and climb have different cylinder temperatures
@stephenj.p.ingley4033
4 жыл бұрын
Awesome explanation...Thanks. JP
@mountainmarauder2575
2 жыл бұрын
Jeez! Does anybody get their head out of the cockpit these days? Is this LOP vs ROP some kind of fad? What's wrong with leaning until it runs a little rough and screwing it back in until it runs smooth and enjoying the scenery. Every IO-520 we had made it to TBO with no problems.
@agentorange153
2 ай бұрын
Leaning by the seat of your pants??? That is NOT how I roll -- and while my choice of LOP vs. ROP is situational (ROP for best power, LOP for best range), I ALWAYS use the EGT gauge to do so! (And that DOES NOT mean never getting my head out of the cockpit -- once I've adjusted the mixture, I can leave it alone as long as my altitude remains constant, which it does most of the time while in cruise!)
@wallywally8282
6 ай бұрын
Power, that’s what flying is all about, oh and speed👍
@agentorange153
2 ай бұрын
That's why, unless I plan to make a long flight without stopping, I lean ROP (75 degrees ROP, to be more exact)!
@StevenYoungcaptual
4 жыл бұрын
Say What??? Lean to CHT?
@TheShays
3 жыл бұрын
Right?
@agentorange153
2 ай бұрын
What's wrong with using EGT like all normal pilots have been taught since the Cold War???
@monrow11
4 жыл бұрын
Wait.....lean with CHT!?!?!?! You lean with EGT. Then monitor your CHT. You run 75-100 degrees rich of peak. Or 50 degrees or more lean of peak. Never use CHTs to lean your engine. You could be at a peak EGT and that’s super high temp and pressure. The Peak is PEAK EXAUST GAS TEMP. Yeah check your cyl head temps. If your too hot then maybe you richen slightly or open cowl flaps or reduce power. These engines should all be operating just fine either rich or lean if peak. As long as your not watching your CHT for the “peak”. But your explaining a bonkers way to lean your engine.
@russellhernandez1875
3 жыл бұрын
All I’m going to say is peak tit for me is around 1650 and I run usually 200 degrees rich of that to keep my cylinders below 400 degrees with 500 degree cylinders. The cht formula works for high performance turbocharged airplanes the best
@monrow11
3 жыл бұрын
@@russellhernandez1875 your still using the EGT to lean your engine. To get to a desired CHT. The TIT is the temp of the exhaust gas going into the turbo.
@russellhernandez1875
3 жыл бұрын
@@monrow11 to a point... in Florida we have way to hot of a weather to lean to peak.. in a turbo we lean to tit compared to egt. It is not cool enough here to lean a turbo Saratoga to 50rop and keep the cylinders under 400 degrees. So what we usually do is start to lean until the cylinder reaches roughly 390 degrees. We do watch the egt but the cht is more of a problem in higher power airplanes.
@StefBelgium
3 жыл бұрын
You did not get what he s saying. You lean as per usual but want to mane sure to not exceed 380° on hottest cylinder. Which is great because regardless of your setting using EGT indication, if your CHT is over 380°, your setting is bad and you re compromising your engine's life.
@ctsteve1967
4 жыл бұрын
Tell lycoming about that
@andy347
3 жыл бұрын
#2 is the hottest on mine! (OK, I have a pusher :) )
@georgehardie2016
26 күн бұрын
Why don’t you show how to accomplish and get to each people that can get to each don’t need this video
@MAGApepe
6 жыл бұрын
:))
@ctsteve1967
4 жыл бұрын
AZ why do you think you know better than everyone else
@HookedOnUtah
4 жыл бұрын
Because he's been building and flying C182s with the IO550 and I0470s for decades, it call EXPERIENCE! He's 100% correct, if you have gami injectors and a modern engine analyzer like a JPI you can fly LOP no problem. And if you've flown LOP you'll see that your CHT's are much cooler and when you do your annual you'll see that you plugs are cleaner etc.
@skidivr
4 жыл бұрын
Read some Deaken and Busch on this. They explain the science behind LOP. The problem is not leaning. The problem is not leaning enough. If you lean just a little you can put your engine at 50 ROP and if the power is high enough you will be at the highest CHT. CHT's are the best proxy for what is happening inside the cylinder. EGT is not. Both Deaken and Busch talk about the red box or red triangle. That explains the concept in one graph.
@monrow11
4 жыл бұрын
D Bradford yeah but you still base your leaning on EGT. To avoid high CHT. Your not sitting there making your initial mixture setting on your CHT. That’s not right. If the cylinders are 385 and you want it a bit cooler....yeah squirt some more fuel into it. Or less if your LOP. But we should be leaning with our EGT gauge first then monitoring.
@winfriedwilcke1705
3 жыл бұрын
@@monrow11 This is outdated thinking. Watch for eg kzitem.info/news/bejne/t6yuy3mHfF9oo20 from 50 minutes onward. (a Mike Busch video)
@agentorange153
2 ай бұрын
@@HookedOnUtah The problem is not leaning LOP (I do that too if I want to get maximum range) -- the problem is using cylinder temps to find your mixture setting, as opposed to using EGT like you should be doing!
Пікірлер: 27