Step-by-step guide on how to replace / remove / change driver side exterior door handle on Chrysler 300 sedan ( 2005 | 2006 | 2007 | 2008 | 2009 | 2010 | LIMITED | TOURING | S | C | 300C | 300S | HEMI | TOURING | SRT-8 ).
Give me your support and join the channel:
/ @quitealright
Honestly replacing and installing new door handle on Chrysler 300 is quite a bit of a project, but definitely doable by yourself. First you will have to remove the interior door panel and disconnect all wiring. Detach interior door handle rod. Then remove the water shield. Detach 2 rods going to door lock and outside door handle. Remove two 8mm screws holding the lock. At the end remove one 8mm screw which is holding the exterior door handle.
Thanks for watching.
Don't forget to Like the video / SUBSCRIBE to the channel!
⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Негізгі бет Автокөліктер мен көлік құралдары Chrysler 300 - EXTERIOR DOOR HANDLE REPLACEMENT / REMOVAL (2005 - 2010)
Пікірлер: 12