Better hack for caliper compressing. Pop the bleeder and compress slowly. It’ll be much easier to compress and outs less pressure on the system.
@alyoungcuda
5 күн бұрын
Up here in the Northeast with all this Rust..that bleeder could snap off and you're in a different position....
@Grimzik
5 күн бұрын
@@alyoungcuda I’m up in those parts brother.
@peatier7626
Жыл бұрын
after taking off tire, take out the top bolt with the rubber boot, the whole thing then pivots sideways off the disk like a printer cartarage and opens enough to get pads off reset pistons and new ones on, indident change clips but they where accessable
@alyoungcuda
Жыл бұрын
you didn't change out the rotors, the problem with that will be a noise and the pads will not break in properly on the glazed rotor..did you peek at the rear rotor surface? Most of the time it looks way different than the front you see and you should change the hardware.
@peatier7626
Жыл бұрын
i just threw some sand in there before i closed it up to keep it smooth and quiet lol jk it's all good no rust anywhere, no squeaks went down a mountain, i'm curious to see what happens, did ya know u can use tire iron that comes with the carjack to take off the larger bolts on breaks :)
@GeorgeDutch
6 ай бұрын
Completely skipped installing the pads into the clips. Terrible.
@alyoungcuda
6 ай бұрын
If you didn’t pay attention to how you removed the pads off the clips on the bracket, this job is not for you..you just need to reverse the way you removed them.
@jackdenial1500
Жыл бұрын
good video, just to add.... missing greasing the caliper pins, otherwise it may be stock the next time you do brakes and stuck caliper pin may cause uneven ware of the brake pads also.
@alyoungcuda
Жыл бұрын
I always check them, if they move, I leave them alone.
@keithhiggins8610
Жыл бұрын
Thanks for the video this is the only video I found with dual piston brakes for town and country. Is the torque the same as single piston 126 and 26? Thanks
@alyoungcuda
Жыл бұрын
Yes and thanks for watching too...
@danbale8042
Жыл бұрын
Too many things videoed out of order.
@alyoungcuda
Жыл бұрын
So what order did you use to do your brakes? We will wait for your Video...
@chaotichomesteading
Жыл бұрын
Would have liked to see you put the brake pads in the caliper. I am having a tough time getting them to go in correctly without being forced
@alyoungcuda
Жыл бұрын
@@chaotichomesteading when the new clips are installed, its always harder to get the new pads on for sure
@danbale8042
Жыл бұрын
@@chaotichomesteading Do NOT skip the wirebrushing as he shows in the video! The pads should be movable with just a little effort. Also, when replacing the clips, make sure you take note of which of the two clips are used in each spot. I made the mistake of mixing those up on another vehicle a few years ago; once I got them right, it was a night and day difference.
Пікірлер: 17