Thanks for the informative video Tharakak, it was very helpful. People who find the video too fast just change the video speed to 0.75
@loupertech
7 жыл бұрын
Thank you for creating this video., Unfortunately, after needing to rewind for the third time, I've determined it might be less time consuming to just find a different video to watch.
@vikas9358
7 жыл бұрын
Just change the video speed to .75
@sherazjaved280
5 жыл бұрын
Many many thanks Mr.TK. Great Video at the right time.
@vpatani
8 жыл бұрын
Very nice production configuration Video. Thanks for your time and sharing
@GoodGameOKC1
10 жыл бұрын
Great vid. Thank you for sharing your knowledge.
@wandjlaye_godwe
3 жыл бұрын
Great Video, took me straight to where I wanted to be .... Thanks a lot.
@boydreamer2551
6 жыл бұрын
thank you! very nice explanation and config
@CarlosSouza-ij3ko
7 ай бұрын
Thanks for this video.
@vaishakpd3867
5 жыл бұрын
Thank you, u did a great job 😍😍😍
@atl5150
7 жыл бұрын
Well done, thank you.
@samdavis7769
3 жыл бұрын
Great video tharakak! How would you configure layer 3 on the access switch for testing with the N7K? SVI's, L3 Po, or Lo0?
@ejeangilles
8 жыл бұрын
Does your fex #'s have to match on both sides or can you have different numbers on each side. Will the configuration work the same if you have different fex #'s?
@pdiab
9 жыл бұрын
i agree...why the rush ? :-) it is a good video though
@sirimolugu9
9 жыл бұрын
The video is very informative, but you are too fast.. Had to listen this again and again to understand clearly.. Thank you..
Пікірлер: 17