This video should be called "How to replace timing belt mostly one handed".
@Johannes_Brahms65
Ай бұрын
I read that one should replace the crankshaft pulley because of the rubber centre. Well made video, thanks! Can you run the engine without coolant even for a few seconds, since the coolant lubricates the waterpump?
@MrRanDomUk
3 ай бұрын
thanks for the vid, changing mine next week
@Tomgrannas
5 ай бұрын
Thanks for the video it helped me
@mykolatrufen4531
4 ай бұрын
Thanks for the video
@ollvals1562
5 күн бұрын
is there a hole in the flywheel for the bolt
@FreedomMatter
26 күн бұрын
Did you replace all the bolts?
@PaulBroadbent-kw3hd
Ай бұрын
Can you remove starter safely without disconnecting battery ???
@FreedomMatter
4 күн бұрын
Can this general tutorial be used for all PSA 2.0L diesel engines of the DW10 series? Torque and operating steps?
@kristofferh2137
4 күн бұрын
It should be almost the same i think, but not sure
@FortyDogCake
11 ай бұрын
Спасибо!
@kristofferh2137
11 ай бұрын
Tang yo tang joo
@voynata7426
4 ай бұрын
Hi do you remeber what size botls did you use for the marks for crankshaft and camshaft, thanks!
@vhmanu3263
2 ай бұрын
Camshaft 8mm
@vhmanu3263
2 ай бұрын
For crankshaft I don’t know
@matthewdavies6722
7 ай бұрын
You don't need to take the engine mount off
@edwardmurray8507
5 ай бұрын
Hey, did you use silicone AND paper gasket on water pump? Thanks
@kristofferh2137
5 ай бұрын
Hi, yes . Worked fine, Nice that it holds the gasket also when installing
@edwardmurray8507
5 ай бұрын
@@kristofferh2137 ok cool, I have the gasket sealant... I need to buy timing belt kit tomorrow made by INA as that is what I have fitted currently.
@edwardmurray8507
5 ай бұрын
@@kristofferh2137 do you have the torque for the main crank bolt? Thanks
@kristofferh2137
5 ай бұрын
Okay yes you can see it in video at 19:40 "crankshaft pulley bolt" hope it goes well! 👍
Пікірлер: 27