Thaks AK speedo for this wonderfull instruction! Which pins did you use for powering it on and at which voltage?
@nldestinyx1440
4 жыл бұрын
Why did you put the needle all the way to the right when powering it on?
@varali
4 жыл бұрын
take the needle off more easy way get a bit of string thred it so its under the needle where shaft of the needle is behind and kinda pull the needle off with the string and holding the needle too.
@rikkilambert311
3 жыл бұрын
hi fella, I've just bought an aygo and I didn't notice when test drove the car as it was in rush hour traffic but the speedo doesn't work, the needle won't go past 30 but I'm doing 50 mph when it reaches 30mph is this video the fix for this problem?
@goldensilence7967
4 жыл бұрын
Hi ..how are the bulbs updated please ..have a speedo out..want to change the led colours
@tz6414
2 жыл бұрын
That soldered lcd screen is cheap . Makes everything so much harder to repair
@akspeedo
Жыл бұрын
Sure does! cheers
@braveridecry
4 жыл бұрын
Thanks for this!
@andriydanylko7165
3 жыл бұрын
The total mileage meter is stuck in place and shows the same mileage all the time. What could be the problem?
@gertversteeg3045
3 жыл бұрын
I have a Toyota 107 and the LH led on the display does'nt work. What to do?
@leseriath
4 жыл бұрын
Hi nice video very useful, can i ask i have a peugeot 107 in with no low fuel chime? I notice the chime for the driver seat belt has been deactivated would this also deactivate the low fuel chime or could it simply be a blown fuse or chime component? Any advice greatly appreciated keep up the good work and videos
@akspeedo
4 жыл бұрын
Possibly the little speaker damaged or faulty, cheers
@SMC9184
4 жыл бұрын
Really useful video tutorial, please could I ask where you sourced your motor from as I have a similar project to undertake. Thanks again for the video!
@akspeedo
4 жыл бұрын
We do have them, but out of stock at the moment. Thanks James
@SMC9184
4 жыл бұрын
@@akspeedo Hello James, I think I have manged to source one. Thanks all the same. Not sure what exactly goes wrong in them as both coil resistance were similar and beyond the 2 cogs looked okay. Not sure what happens to magnet, but I was suprised how simple these devices were.
@akspeedo
4 жыл бұрын
No problem Thanks James
@kampatel99
4 жыл бұрын
The RH indicator LED doesn't work on my C1, is it possible to replace it on the circuit board? It looks like it would be tricky.
@akspeedo
3 жыл бұрын
Yes, James
@windsurferMARC
4 жыл бұрын
Do you have the power pin out for me please? Connector
@RSx94
3 жыл бұрын
I purchased an Aygo today and it got a minor problem. All the turn signals work fine, but it doesn't blink to the left in the speedometer, when I enable the left turnsignals. It does blinks and work when using the right signals. What can be the issue? A bad LED?
Пікірлер: 22