thank you for all your video, i learned a lot. this is a great resource for this topic.
@awdarda
7 жыл бұрын
Thank you for your great video.Was looking for this for long time. Very helpful. I learnt a lot.
@dojovaco
5 жыл бұрын
Nice, thank you.
@evanrambikur1708
5 жыл бұрын
This was very informative for me, thank you. Is it possible to define the gutter data within Civil 3D or only within SSA? Is it possible to do a partial import or update of the existing model into SSA? Thank you.
@tyeasmin
4 жыл бұрын
Hi John, I am one of your fan and learn a lot from your videos. I am facing a trouble in SSA and hoping to get a little help from you. I have a EPA SWMM model and I want to import it in SSA for further improvement. But by doing that the inverts are offset exactly the inverts number of the pipe. For example if a pipe has inlet invert is 350m and outlet invert is 351m, after importing the network in SSA these inverts are just going up double (imported inlet invert = 350+350= 700m and outlet invert = 351+351=702m), which is not right. Would you know what am I doing wrong here? I appreciate your time and help.
@thusithaamarasinghe7824
Жыл бұрын
Can you please explain the design of the vertical pipe using SSA?
@ckong676
6 жыл бұрын
good job
@marcelinodiaz8133
2 жыл бұрын
Hello John, where can you get the IDF curve table files?
@andrewsamuda3266
2 жыл бұрын
Great video. What was your simulation period and how did you select it
@johnsayre4827
8 жыл бұрын
When I did the video, keep in mind I am showing functionality of the software and I was not necessarily concerned with the design. I apologize, I was not focused on teaching design necessarily. Does that make sense?
@2003ximba
7 жыл бұрын
Thank you Sir
@sakhumzitima3213
Жыл бұрын
Hi John, thanks for these videos I visit them whenever I get stuck, but I wanted to ask if it is possible for SSA to automatically optimize and change to adequate pipe size.
@marc07112
5 жыл бұрын
How do you do a bypass link in a field, say like an airport infield area? Direct or gutter? Or do you just say the lateral pipe leading into the trunk line?
@johnsayre4827
5 жыл бұрын
I would probably try a direct link.
@2003ximba
7 жыл бұрын
When you add the "gutter" for bypass flow, we do not have to worry about the length and inverts of the gutter function?
@johnsayre4827
7 жыл бұрын
Correct.
@2003ximba
7 жыл бұрын
Thank you Sir
@Splishsplashin
3 жыл бұрын
@@johnsayre4827 Why do we not need to worry. Are these values not used in the bypass flow calculation?
@peterlee7985
5 жыл бұрын
how did you get all the label be staggered automatically? check video time 6:09
@castled71049
2 жыл бұрын
After setting up SSA and run the analysis, I get the error message "INF is not a valid floating point number." Any idea how to fix this problem? Thank you.
@abdullahn9827
6 ай бұрын
it provides the error number. Get that and look in help manual, you will know whats the error
@karabusch2841
2 жыл бұрын
Anyone know how do you reverse flow direction in version 13.4.133.0?
Пікірлер: 23