Could've used "Selection Cycling" so it's easier to pick things on top of each other.
@MrWebon
4 жыл бұрын
Thank you!
@Civil3dpro04
2 жыл бұрын
Thanks for the great video, I have a question: you draw some lines for driveway or at the intersection ( are they are simple polylines)???
@dionperich_BIM_TRAINER
4 жыл бұрын
Love it. Niice!!
@stevedavidson8856
4 жыл бұрын
Hi, thanks for a great video. I’m wondering if you’ve come across a problem that I’ve got with conditional cut or fills. I’m working on quite flat ground and I have a condition that requires a safety bund to be installed on a haul road once a nominated fill height is exceeded, I can get all that to work but an issue occurs when the fill height is getting close to the nominated height. At one sample line the height is exceeded so the bund is installed, at the next the height is just slightly below the limit so no bund is shown, and at the next it’s exceeded again. So the result is bund, no bund, bund. In reality we’d put the bund all the way through all three points. I’m thinking that the best solution is to make a “dummy” surface to target to and when we get the above situation we just locally lower the dummy surface and thus force it to install the bund. Likewise if the conditional cut or fill is showing one tiny segment with a bund but nothing either side we’d locally lift the dummy surface to stop the bund being shown. Any better ideas? Thanks again for making the video.
Пікірлер: 6