Great video, I have solved my greatest challenges while drawing intersections. Thanks
@cadiotsavant2397
11 күн бұрын
@@asaphowuor3476 thanks! Let me know any other workflows you want to see.
@carlnessfit101
3 ай бұрын
Thanks for showing work flows for more advance users. Make more videos please.
@cadiotsavant2397
11 күн бұрын
@@carlnessfit101 have any suggestions?
@vmmijangosc
Ай бұрын
Excellent tutorial!! I was able to do almost everything, but not the connected alignment profile. Don't appear the line of the alignment just the grid, what am I doing wrong? I followed all the instructions
@cadiotsavant2397
11 күн бұрын
@@vmmijangosc sounds like you might not have the right elevation range. Or it’s all at zero. Set the elevation range to automatic. See if that works
@vmmijangosc
11 күн бұрын
@@cadiotsavant2397 Thank for your help. The problem was that when I create the connected alignment, I set the connection overlap to 0.01 m and it did not take the elevation of the offset alignment, instead it took 0.00
@nehemiahstewart
Жыл бұрын
Well done. Thanks!
@pmcatnip
6 ай бұрын
This is a great video, but I am very new to Civil 3D and don't know how to get to your starting point where the corridor exists everywhere except the rounded areas. Is it corridor regions? Would you be willing to share the dwg file? Thank you :)
@luyolomagwebu389
Жыл бұрын
If it's not too much of an ask, could you please do a video on how you set up profiles for an intersection with both crowns maintained vs only the primary crown maintained
@cadiotsavant2397
Жыл бұрын
How would you drain the returns? I can do one I just need more specific info.
@luyolomagwebu389
Жыл бұрын
@@cadiotsavant2397 Maybe sheet flow out of the returns onto drains placed along the roads.
Пікірлер: 12