Ur doing a great job for your 1st time man. There's a lot of unanswered questions out there concerning wiring for going OBD1 specifically pertaining to the EF and CR-X chassis an I'd say this covers most of em an should def help out alot of ppl.
@vtecnerd
Жыл бұрын
Thanks, glad to hear this is as useful to others as it would have been to me!
@Alexei55555
5 ай бұрын
AutoDoc power :)
@marcohuertas692
2 жыл бұрын
Where can I buy the sub harness?
@victorl9205
2 жыл бұрын
Great post! Please do an update on the CJ wire harness routing to all sensors on the engine. Just curious on how the harness looks in the engine. Are the wire leads too short or too long to each sensor? Did you have to tidy up on the leads to the sensors? Again thx for the info 👌
@vtecnerd
2 жыл бұрын
Thanks for the feedback! Will make sure to do a video covering how it looks when installed
@joshbrown5610
Ай бұрын
Where do I buy sub harnsss
@brunopt2406
26 күн бұрын
Do i need that sub harness to run a d16 obd1 or is it only for the obd2 engine? My chassi is obd0 so if i use a cheap obd1 swap harness i need that sub harness still right? Thanks
@vtecnerd
26 күн бұрын
@@brunopt2406 I don’t know, sorry. This is my first engine swap. I recommend you do some research. If you have the engine and ECU already then start looking at what plugs you have and what plugs you need.
@jordanaustin2932
Жыл бұрын
Got a link to where i can buy it mate ?
@salvadorrodriguescorona2911
2 жыл бұрын
Could you tell where you bought it or share the link?
@vtecnerd
2 жыл бұрын
www.cjs-wiring.com/
@edvas02271
2 жыл бұрын
Was your car dual point or did it already have 4 injectors?
@vtecnerd
2 жыл бұрын
It was DPFI, but I'm swapping in a B18C4 which is MPFI. So included in the swap harness is an MPFI conversion.
Пікірлер: 16