First video on this topic that I fully understood how it's supposed to work. Others just gloss over it. Thank you so much, it will be a great help!
@iankenningham725
Жыл бұрын
Hi there Firstly your videos are very informative. Could I ask did you replace your differential bearings or put the original ones back in .many thanks Ian
@mrfid72
Жыл бұрын
Thanks for your comments, and yes i did replace the diff bearings. they came with the kit.
@andrewhurst1472
10 ай бұрын
Another question, how did you get your housings so clean and shiny?!
@mrfid72
10 ай бұрын
It seems to go by loads of different names, but i call it bead blasting. its glass bead in water and that is pumped out of the gun with compressed air to give it more power. I think its a brilliant machine and we are lucky to have one at work!!! maybe the question is how long will the finish last?
@andrewhurst1472
10 ай бұрын
Is it safe to assume that compression of the gasket and hylomar after torquing and re-torquing do not need to be included in the calculations? Also, I have seen other folks do this without the diff cover in place yet, which seems to make for easier access and visuals. Do you have a reason for preferring the way shown? Thanks for taking the time to clarify this murky area. The manuals do not do it justice.
@mrfid72
10 ай бұрын
Hello and thanks for your comments, i spent a while trying out different gaskets and with each one i measured before and after tightening and to be honest i couldn't measure any difference, so i didn't include and crush value. The hylomar may have made a little difference but i only put on the slightest smear and re-tightened after a few hours so again i dont think it would have made much difference. I cant see a reason for leaving the diff cover off as you have 3 fasteners in that section and there are only 5 in total so would it not be even??
Пікірлер: 7