It's a bad habit to use ultrasonic cleaners for print heads. This can cause microscopic pitting in the head's nozzles which can lead to nozzle deflection and other forms of misfiring. It's recommended to use cleaning solution with a multichannel peristaltic pump. It will take longer but wont run the risk of damaging the printhead.
@miklfaradey7306
Ай бұрын
that's exactly what I do. I assembled a special stand for this with a peristaltic pump
@djgrandauto8541
Жыл бұрын
I bought that after watching video. Works as advertised
@egud2472
Ай бұрын
-))))))))))))))))))))))))))))))))))) Брехло! На видео не показан результат работы. С таким же успехом можно снять видео, как моют огромную хрустальную люстру шваброй - намочили, накорявили, а пыль так и осталась, да ещё люстра поломана.
@lorenzostewart9185
13 күн бұрын
Can i use this for xp600 print head?
@BCHTechnologies
12 күн бұрын
Not for the core. For the manifold, yes.
@cobrafiregraphics9855
Жыл бұрын
Kevin, I used an ultrasonic cleaner on my l1800 head, and possibly ruined the membranes,can these be repaired?
@egud2472
Ай бұрын
Кевин на такие вопросы не даст ответ)) Ответ очевиден - нет. Держитесь подальше от Кевина.
@egud2472
Ай бұрын
Автор не здоров на голову. Люди, не повторяйте это и не покупайте бесполезные вещи.
@VITcz
Жыл бұрын
Hello, thank you for this video.. are there any specisfics that I should look for before buying ultrasonic cleaner or this one from video should be just fine? Also I wanted to ask, should I clean dampers or just buy new ones?
@blasterfelix85
Жыл бұрын
Hello, a question so to clean an epson et2721 printer head in the ultrasonic tank I can't immerse it all? Or are there gaskets that would break? What temperature can it be set at?
@jcmoney11111
Жыл бұрын
So can you successfully clean the L1800 printhead if you seperate the manifold feom the head and leave the gasket /membrane off.
Пікірлер: 14