The screw on the bottom of the bowl is a drain screw. Open it to drain fuel out of that bottom nozzle. The hose that was split is a breather hose. Adjustments are idle (on the needle valve tube) and air screw (side of carb between air filter and needle valve).
@jarrodreese3987
Жыл бұрын
Great Video, big help to watch someone before doing it yourself. Just completed a carb replacement. Thanks 👍🏻👍🏻
@blackicethehusky5894
6 ай бұрын
Thank you for this guide my 86 carburetor stop working recently and wanted to replace it with a new one this helped out greatly
@radozeman
6 ай бұрын
Glad it helped
@brysonsadventures9955
5 жыл бұрын
What bothers me is that he didn't take the fenders off, it would make it so much easier😂
@gilbertolugo9055
2 жыл бұрын
I have the same opinion, the work is much easier and comfortable 💪👨👍
@mikeshobbiesandrandomstuff
6 жыл бұрын
Always use a pre oiled air filter for the old slide style carbs these have as the slide and carb body will wear out over time if you don't. Best regards Mike
@radozeman
6 жыл бұрын
Ok
@gilbertolugo9055
2 жыл бұрын
Removing the mudguards would be more comfortable and the work would be more pleasant since it is easier to identify which screws to unadjust, anyway good work, I needed to watch this video since I have one of 1987, thanks brother 💪👨👍
@coltoncarman151
4 жыл бұрын
Love ur shirt
@Glucke
8 жыл бұрын
I have an 87 250trx and my problem was it would putt out slowly, and then die. I rebuilt the carburetor on it, changed the gas filter, and cut off the internal gas tank filter only to learn it was the vapor lock :/ for me on means vapor lock is off and off means the vapor lock is on...
@radozeman
8 жыл бұрын
Yep, I've had that problem before!
@SnowCamo45
2 жыл бұрын
💯💯💯
@CamoPajamies
2 жыл бұрын
Ok so mine is almost like yours you can tell because inside of it has ultra grimy carbon layer. But tomorrow I’m going to use carb/choke cleaner to clean outside like you ride but with it still on the bike with rags. Next use sea foam maybe carb cleaner too after engine is hot and on. Also use the liquid sea foam in tank. This only works when the carb is working fine.
@radozeman
2 жыл бұрын
Did it work?
@troycrowder9942
5 жыл бұрын
next tme you clean that carb get yourself a torch hed cleaning file kit take the smallest one through all of the jet passages
@Dwinston99
Жыл бұрын
Great Video. Let me know what you think my problem is. So once i start it choked it will run a little but once i let the choke out and try to give gas it sputters out.
@radozeman
Жыл бұрын
Clean the carb? Sounds like it's not getting gas.
@Dwinston99
Жыл бұрын
@RDAllen Figured it out. It's a brand new carb that's why I didn't think it would need a clean right now. Turns out the previous owner had the fuel line from petcock to carb 1/4 inch to a smaller tubing and once I replaced it I just needed to mess with the idle. Oh and it needed some gas 🤣
@crankedscope8418
8 жыл бұрын
hi RDAllen could u a stream on Oklahoma and make it more like a trucking video such as a truck driver
@radozeman
8 жыл бұрын
Not sure how well I could live stream with my internet connection.
@crankedscope8418
8 жыл бұрын
+RDAllen no i mean make a video of it and post it
@Ears82
Жыл бұрын
Did you pit the hitch on? If you have any info on it, it would be appreciated. I have the exact same 4wheeler and having trouble finding one.
@West-SanJo
3 ай бұрын
I just bought a 86 200sx.. can you tell me what those levers are on the right hand side ? Mine only has a throttle nothing else..
@changofeo9795
3 жыл бұрын
I need help with my 87 200sx it starts first pull but wont idle so i have to hold the throttle. And if i let it shut off it struggles to start again for a few minutes. Could be running rich but idk
@radozeman
3 жыл бұрын
There is an idle adjustment screw if I remember correctly, don’t know if that will help though. Very similar to the problem we had, never did fully figure out the problem.
@changofeo9795
3 жыл бұрын
@@radozeman ive tried it before the engine just starts revving up by itself
@nickl3ko
3 жыл бұрын
I’m trying to get my 86 up and running. How did you get the left side bolt off to take the carb off? The right wasn’t to bad but still not fun the left I’m struggling with
@brysoncowan7642
6 жыл бұрын
I got a 87 honda fourtrax trx 200 its flooding bad took the air filter off its just pour gas out of the carb into the air filter
@radozeman
6 жыл бұрын
stuck float maybe?
@brysoncowan7642
6 жыл бұрын
RDAllen it is i tried tapping the carb were the floats at its worked so far but now i got too weld the frame its completly broke on one side and almost completely broken on the other side
@Xenomorph2022
7 жыл бұрын
Would it be the carburetor or something else?
@radozeman
7 жыл бұрын
Could be, how long does it run, only a few seconds or a few minutes. Only few seconds could be the carburetor, probably something else if it runs longer, maybe ignition coil?
@crazyashtengaming2888
8 жыл бұрын
Cool
@adamsnyder1844
Жыл бұрын
Pulse generator, $30 part, try that yet?
@thecollector5209
3 жыл бұрын
i have had same problem but my airfilter looks red
@stevepm6351
2 жыл бұрын
LOVE that shirt 🤣🤣🤣🤣
@radozeman
2 жыл бұрын
Thanks lol
@Codyf92
7 жыл бұрын
Nice shirt.
@radozeman
7 жыл бұрын
thanks
@Xenomorph2022
7 жыл бұрын
Could you tell me what is wrong with mine. I have a 2007 TRX250ex and it will run and the like kinda sputter then die
@wyattthedeerhunter8010
4 жыл бұрын
Zachary Tilson mine is a 2001 Trx250ex and mine does it too
@kylewil12plays
8 жыл бұрын
I figured that was a transmission not a chain drive
@radozeman
8 жыл бұрын
It has a transmission with chain drive to the rear wheels.
@kylewil12plays
8 жыл бұрын
+RDAllen that's interesting seeing as I'm pretty sure my 85 three wheeler dosent have a chain I think it's just a transmission shaft to the rear
@radozeman
8 жыл бұрын
Really? I would have thought that would have chain drive as well.
@kylewil12plays
8 жыл бұрын
+RDAllen don't think so my family waited tell 85 so it wouldn't have a chain I believe
@nickdaniels4347
3 жыл бұрын
I have one like that 86 honda fourthax 200sx 4stick
@radozeman
3 жыл бұрын
Nice little fun four wheelers!
@pierresalicco8633
4 жыл бұрын
Thank you !! You may want to look at this video... kzitem.info/news/bejne/lYGEr4eLhKeCqo4 After years of idle problems with my Fourtrax 250 I finally fixed it by moving the C-Clip one notch away from the center... Easy fix and worth a try !
@josephfilter7413
8 жыл бұрын
what kind of tires are u running in the back
@radozeman
8 жыл бұрын
Bear Claws
@hexer5710
8 жыл бұрын
r u Canadian u sound like it
@radozeman
8 жыл бұрын
No, from Michigan.
@skylerrodgers1124
7 жыл бұрын
I have same year model and type of atv as that my carburetor is shooting gas out of the two little holes right under the air intake thing does that mean the float needle is stuck or what? I need help i has problems starting in weather 40 degrees and under is that un usual?
@radozeman
7 жыл бұрын
Yes, more than likely your float is stuck or is dirty. Sounds like a good rebuild/cleaning of the carburetor will probably fix both problems.
@joebuck5052
7 жыл бұрын
RDAllen what size tires are in the back
@sarffman
2 жыл бұрын
It would be nice if you actually had close up shots of what you are actually doing, this video Doesn't help much.
@mikeatv
3 жыл бұрын
throwing the airbox is not a good idea....btw good work dosnt need to be rushed through jmo
@nacholibre1962
2 жыл бұрын
Use proper equipment in the workshop, and that includes your footwear. Even dropping a tool, such as a wrench or pliers, on a bare toe could break it. Flipflops have no place in the workshop!
@troycrowder9942
5 жыл бұрын
that is not a stock carb for a honda that is a china
@radozeman
5 жыл бұрын
The carb that in there is not stock? That would be interesting and possible explain a lot.
@mikeburkhart6707
4 жыл бұрын
@@radozeman Looks stock to me. Chinese ones have white floats.
Пікірлер: 65