Joel , as you told me over the phone: 1)THE handle bars MUST be on the ENGINE side ( you go over this at 7:48- 9:50 in the video but it is SO IMPORATNT that it should be made very clear at the very start because you cant do the adjustment loose enough unless the handle bars are on the ENGINE side ) 2) if tightening lower cable clamp tension the upper tension adjustment thread must be 1/3 - 1/2 showing BEFORE pulling the lower cable tight .
@jimminycricket3384
6 жыл бұрын
Super helpful. I needed to adjust my cable after replacing my clutch as the machine wasn't stopping moving forward when I disengaged the clutch handle, and this seems like just the advice I needed. Thanks!
@TheNerdiephresh5
10 жыл бұрын
Thank you! I developed the need for this adjustment after about 10 hours of usage on a new machine. This was helpful.
@ChrisSchraders
8 жыл бұрын
All of these videos are super useful. Thanks Joel!
@timharpham749
6 жыл бұрын
Thank you for the videos! Saved us both time on the phone.
@FILIPFROMSALMO
12 жыл бұрын
Nice job Joel, thanks
@romeotangofoxtrot
12 жыл бұрын
Outstanding video!
@costoncheatham7025
4 жыл бұрын
Might the need for this adjustment also contribute to the clutch being frozen in the off-season? I had the clutch dis-engaged last off-season, but noticed that it was frozen a bit when I started using it this year. After some initial use, it broke free. But... I still notice that the gear will still be engaged ever so slightly sometimes even when I have the clutch completely open.
@small-timegarden
5 жыл бұрын
Having problem with my clutch cable. Need it changed. Video?
@gepetto4
10 жыл бұрын
Nice tutorial. Am looking for direction in freeing up a stuck clutch on a 710 I bought used. Any do-it-yourself advice?
@EarthTools
7 жыл бұрын
See our website...we have a section of how-to pdf docs, and one deals with this. www.earthtools.com
@billstone6688
7 жыл бұрын
I have adjusted the clutch according to the video above. I tried turning the adjustment all the way in and all the way out. At this point the nipple or nut that sits in the handle is all afloat. I have adjusted the total cable under the battery case both by lengthening cable and by shortening the cable. No matter what I have tried, once the machine is in gear, it moves regardless of the clutch position. Any theories?
@joeldufour6202
5 жыл бұрын
We mention in the video that if adjusting the cable does not make it "stop", your clutch needs new bearings... we offer a rebuilding service for the BCS clutches. 502-484-3988
Пікірлер: 14