In this video I will be installing a 24v Electronic Pneumatic Valve in an OMTec h 60w CO2 Laser. The benefit of this valve is to have control over your air assist in the Lightburn Software. I have listed the parts used in the links below. Please remember to **UNPLUG YOUR LASER MACHINE BEFORE ATTEMPTING ANYTHING YOU SEE IN THIS VIDEO**!!!
24 Volt Pneumatic Air Valve: a.co/d/09SwOhN
Terminal Block for Ruida Controller: a.co/d/6vKWy2H
Rectifier Diodes: a.co/d/8rZt6il
6mm Tube and Fittings: a.co/d/5tkNy3D
OMtech CO2 Laser Machine:
The information provided on this channel is for entertainment purposes only. Any action you as the viewer takes upon the information on this channel is strictly at your own risk, and I will not be liable for any losses, damages, or personal injuries in connection with the use of this content (including injuries, damages, or losses sustained while you were trying to emulate the actions and projects on this channel). Attempting to emulate any of the actions or projects put forth by this channel should not be done without training and even then, at your own risk.
Негізгі бет Тәжірибелік нұсқаулар және стиль CO2 Laser Air Assist - Installing Electronic Pneumatic Valve
Пікірлер: 14