Simple enough fix. Well done of the video. 👌🏻 Have a good one!
@Radionut63
2 жыл бұрын
Thanks, you too!
@MrGsmith333
11 ай бұрын
Hello from Spokane Washington USA 🇺🇸
@Radionut63
11 ай бұрын
Hello there! 😊
@dowutchado
3 ай бұрын
Hey,I’m not getting any static out my radio,but when I key up I can hear talk back,needle does not move,any suggestions
@Radionut63
3 ай бұрын
make sure that radio is not switched to PA
@Tobinindustrial
2 жыл бұрын
You got to love the easy fixes. You got me sizing up the motormaster contact cleaner now. That should be a cheap product and it is a big can besides. Are you still using the JVC Everio MG630 for videos? If so, that is one tough camcorder.
@Radionut63
2 жыл бұрын
I still use the camera, also have a JVC MG-330RU and a SONY HDR-CX405
@robmclaughlin9709
2 жыл бұрын
Great video as usual and ya gotta love the simple fixes. I have a 3 metre micronta like you were using but it's a bit buggered up would you care to take a look at it? Lol
@Radionut63
2 жыл бұрын
Cool, thanks, sure why not :-)
@duaneshuster6366
4 ай бұрын
Cobra 25 ltd new classic radio .(Front mic connector) Lost its TX found bad connection found off RF transistor but now don't RX I wemgnover everything I did not bridge anything soldered while radio went thru roll wick no luck any suggestions ?
@Radionut63
4 ай бұрын
if there is no sound, plug in an external speaker, if you have sound then, your speaker is blown. Common problem.
@duaneshuster6366
4 ай бұрын
I wish it lost total pll revive ko signals got mod got transmit . . This has been a cobra thing for years ingo should BD in secret CB books or tune up manuals no kind gas ever posted half dead on PLL .
@Radionut63
4 ай бұрын
In that case, power is lost somewhere to the receiver and part of the audio circuit. Check for voltage to the audio amplifier and also voltage regulators, bet you have voltage lost around that amp or a shorted capicitor.
Пікірлер: 14