I had the same problem with my 424 and managed to fix it by loosening the screw on the rear that secured the chamber and moving the assembly downwards then retightened the screw .
@chriswebb6153
2 жыл бұрын
That was happening to me until I realized that the jet tip on the end was loose.
@petemack1745
2 жыл бұрын
Do you have the fuel tank correctly positioned against the front of the stove? Sometimes the handle or latch can hold the fuel tank away from the front of the stove and the nozzle doesn’t go fully into the Venturi.
@bcgrittner8076
2 жыл бұрын
That happened to me one time. I solved the problem by raising the carrying handle to the up position before mounting the fuel tank. Problem solved.
@johnmubuu5551
Жыл бұрын
Have had the same experience
@1pollock405
Жыл бұрын
Sometimes this is caused by a buck nest or a spider web in the manifold that is redirecting some of the gas back towards the generator.
@korkuiper9385
2 жыл бұрын
Turn the litle knob left from the gasknob down after a minut. Put the pressior up with the pump
@pierregiguere2688
Жыл бұрын
Hello Doug, I have the same problem but I cannot get to Sée how you have solved IT. Is there a new épisode showing how to fix this lesk? Thank you. P.
@evil17
10 ай бұрын
This is caused by a leaking nozzle thread, try tightening nozzle down some more, or remove nozzle & add a drop of fingernail polish to the thread & then refit nozzle firmly & let sit to dry properly before use.
@kerrycpcom
2 жыл бұрын
Hello I've got this problem and can not find your part 2 to fix it.
@cesarzeta8497
2 ай бұрын
Perdone usa combustible tiner o gasolina para auto
@iwlu25
Ай бұрын
How will that help?
@Psodracer
2 жыл бұрын
Mine is doing the same thing, I put some aluminium foil around the tube to cut the space and it's solved!!!!
@alfonsocasillas7290
2 жыл бұрын
I had the same problem use yellow plumbers tape
@jeffccr3620
Жыл бұрын
So the gas Teflon fixes this problem on the jet? I have a 425e I just picked up that's doing the same My first thought was I might have picked up some trash out of the tank obstructing the needle but after cleaning everything up I still get this flame
@evil17
10 ай бұрын
There is a leak in the thread seal. Remove nozzle & either add yellow thread tape or fingernail polish to the thread & refit nozzle firmly to seal.
@ronytobadak5431
Жыл бұрын
sy buat hal yg samam tp permadalahannya sering api menyambar masuk dan mengakibatkan api mati,,mohon solusinya pak 🙏
Пікірлер: 18