Abstract: Non-oxide ceramics, including sialons, silicon carbide (SiC) and silicon nitride (Si3N4)-SiC composites, are of great interest for high-temperature refractory applications due to their unique combination of excellent chemical, mechanical and thermal properties. They possess an exceptional resistance to wetting or corrosion by molten non-ferrous metals, compared to other refractory oxide-based materials, high strength at ambient and high temperatures, and good thermal shock resistance. However, the reliability and the fabrications costs still need to be further improved to increase their industrial attractiveness and performance in service. Colloidal processing, which has the potential to destroy the particle agglomerates and control the interactions forces between the particles is a key approach to achieve these challenging targets. However, in multicomponent systems that include powders with much different surface chemistries, etherocoagulation is likely to occurs when dispersing the powders in aqueous media. Moreover, some powders like aluminium nitride (AlN) are water sensitive and undergo hydrolysis, leading to their degradation and formation of by-products. Therefore, solvent mixtures of methyl ethyl ketone (MEK) and ethanol (E) were selected as dispersion media to enhance the surface chemistry compatibility of the different starting powders. Moreover, a comb-like copolymer (Hypermer KD1- Imperial Chemical Industries PLC, England) was used as dispersant due to its versatile architecture consisting of two types of segments, one with high affinity to solid particle surfaces, and the other with high affinity to the solvent. The solvency was further changed by varying the MEK/E volume ratio. The effects of MEK/E solvent mixtures on reaction sialon (76.92-wt.% Si3N4 + 13.46-wt.% AlN + 5.77-wt.% Y2O3 + 3.85-wt.% Al2O3) suspensions were investigated by measuring sedimentation behaviour, adsorption of dispersant and flow behaviour. The efficacy of different homogenizing procedures: high energetic planetary milling, low energetic ball milling and ultrasonication. The effects of different homogenizing routes on the rheology and the maximum achievable solids loading of suspensions and on the properties of slip casting green bodies were also evaluated and compared. It was shown that both the flow behaviour and sedimentation behaviour strongly depended on selection of solvent composition. Using 3-wt.% KD1 as dispersant, well-dispersed colloidal suspensions could be obtained in MEK-rich solvents. Further, the high energetic planetary milling revealed to be the most effective deagglomeration route, enabling to prepare highly concentrated suspensions when powders are dispersed in the azeotropic solvent mixture (MEK/E = 60/40). Predicted adsorption models with varying solvency are proposed. The green bodies with high density could be easily pressureless sintered, leading to homogeneous microstructures of self-reinforced α-sialon with elongated and intermingle grains, enjoying of the greater hardness of α-sialon phase and of the typical higher toughness of β-sialon polymorph. The decreasing solvency of the dispersant with temperature were also exploited to develop a new temperature-induced gelation method and direct consolidate green bodies of SiC and silicon nitride Si3N4-nano-SiC composite ceramics.
Keywords: Colloidal processing; steric stabilization; solvency; rheology; non-oxide ceramics.
Full Article: www.proceedings.iaamonline.or...
Join us: www.iaamonline.org/
Негізгі бет Colloidal Processing of Advanced Non-Oxide Ceramics - A Way to Engineer Hard and Tough Materials
Пікірлер