In this video we will glow Common Anode RGB LED with Arduino controller and manual, We also have breadboard power supply to test. you can watch hardware set for Arduino to glow LED.
In this project we have used Breadboard, Breadboard power supply, 10mm Common Anode RGB LED,
Arduino Uno board, 5v power supply as single cell power bank,
Electronics, technical, electronics projects, electronics DIY projects, electronics review, electronics experiments, Electronics, Electronics review, electronics experiments, Technical electronics, Playing with electronics, Fun with electronics, Electronics components, electronics education
-----------------
Music: Rio Blastar [Original Mix] by Imperss Music is licensed under a Creative Commons License.
IMPERSS Music Official
/ imperssmusicproduction
Support by RFM - NCM: bit.ly/2xGHypM
creativecommons.org/licenses/...
-----------------
DISCLAIMER:
CONTENT RISK OF FIRE HAZARDS, ELECTRIC HAZARDS, CHEMICAL HAZARDS AND OTHER HAZARDS.
DON’T TRY THIS AT HOME, SCHOOL OR ANYWHERE ELSE OR DO IT YOUR OWN RESPONSIBILITY.
CONTENT CREATOR IS NOT RESPONSIBLE FOR ANY DAMAGES AND LOSSES.
VIDEOS ARE CREATED FOR ENTERTAINMENT AND FUN PURPOSE ONLY.
-----------------
#diy #diyelectronics #howto #howtomake #review #testing #diyfun #electronicsfun #electronics
#CommonAnodeRGB #Arduino #10mmLed #breadboard #breadboardpowersupply
#Arduinocode #invertcolors
Негізгі бет Ғылым және технология Common Anode RGB LED, Hardware setup for Arduino and Manual testing.
Пікірлер