bro, you gotta use some shims. trying to float them with your fingers isn't exactly accurate....
@wutupclegg6618
11 ай бұрын
True, if I was just spinning it. On this unit, if you line up the top and bottom numbers, then the reading will be accurate. Check out the video I did on how to use the Rotor Master. I made sure to get the approval from the designer of the rotor master.
@BULLYDOGKYLE
11 ай бұрын
Dog is correct. The way you are getting the rotor strength is incorrect. You have to shim the rotor to center then rotate the rotor to get accurate readings.
@BULLYDOGKYLE
11 ай бұрын
Find center first with shims. Reset the reader. Then rotate the rotor 1 revolution. This will be way more accurate.
@wutupclegg6618
11 ай бұрын
@BULLYDOGKYLE I get what you're saying. However, if the top a bottom numbers are aligned, it does not matter. It allows the full reading of both north and south. Even the designer of the machine agrees.
@BULLYDOGKYLE
10 ай бұрын
@wutupclegg6618 when you were getting some of your readings you were 40-60 off. Just trying to help you out be more accurate.
@bonesracin3255
11 ай бұрын
Surpass a beast
@wutupclegg6618
11 ай бұрын
So far, it's my favorite.
@bonesracin3255
10 ай бұрын
@@wutupclegg6618 Bumped up into the amain with lightweight yesterday. Semi tight, hi grip clay. Was in fresh b6.4 . Tried a couple different gears. 29 was my best consistently but 30 was a blast
@wutupclegg6618
10 ай бұрын
@bonesracin3255 that's what I like to hear!!! Nice Job! These motors are beasts.
Пікірлер: 11