Excelente. Claro y bien planificado. Gracias por tomarse la molestia de filmar todo el proceso. Saludos.
@bullyboy585
3 жыл бұрын
I love the card board diagram
@alexespinoza1928
6 жыл бұрын
- Intake body(
@richardus46
10 жыл бұрын
Great videos. I used to have 3 different XR600Rs. From all bikes i had, the XR i liked most. For me ENDURO = XR600R
@lbneil
4 жыл бұрын
Love your vid no skipping on the details
@dannystruck4107
7 жыл бұрын
great videos man, love how you list everything in the video at the beginnings, makes it easy to find which video i should be watching lol
@XRLand
12 жыл бұрын
That's a great deal you got there, and sounds like the bike will have a good home! Good luck on the build, and enjoy that fresh new engine smell. ;)
@skirrtmainey2405
8 жыл бұрын
Sound and a little narration would be nice!!
@XRLand
12 жыл бұрын
@XRLand To add to that, if you are talking about the big end of the rod you only need feeler gauges to check the free play. Hope everything works out well. By the way when I measured my rod small end and wrist pin I was within service limits but still had noticable play.
@zesilveirinha
11 жыл бұрын
Good job. I'm learning a lot with these videos. Thank you!
@user-sq9cm6kh2p
2 жыл бұрын
Puento al punto
@XRLand
12 жыл бұрын
@MrDarren777 Hey McDarren there will be a tiny bit of play on the big and small end of the rod, but to be sure you should measure them with a digital caliper and see if they are within the service limits. The service limits are found in the service manual, and digital calipers can be found for as low as 10 dollars. If you don't have the manual I can provide you with the figures. Are you replacing the piston and wrist pin?
@robbiejohnson2435
3 жыл бұрын
How’d you get the timing chain off?
@MrDarren777
12 жыл бұрын
good job , ive got one for you ive got mine torn apart now .ive got a little slop in my rod should this be tight
@BurkeLCH
9 жыл бұрын
3:30
@candybarpopsicle8883
10 жыл бұрын
sure would be nice if I could hear some sound
@boomstickbelgian2775
8 жыл бұрын
Hey man, i removed all of my cylinder bolts (the 4 big ones too) but i can't get the cylinder off for the life of me... any tips?
@WestCoastADV
9 жыл бұрын
XRLand
@TheSlightlyaverage
6 жыл бұрын
Hi, I'm just putting my cam back in after a rebuild and was stumped by the cam bearings. They have a seal on one side?? I've checked out your videos and you seem to of put them Back in around the other way?? Which way should they go??
@MXRiderFiftyTwo
10 жыл бұрын
Hello,My 1995 XR600 is pissing oil from head cover( Decomp seal has gone)...can i remove cover while motor is still in frame?..
Пікірлер: 38