Love the rig! Is that front 14 bolt spec’d out to a gm dana 60 kingpin? Same shaft lengths, etc? How was the fitment with the drive shaft next to the motor? Thanks!
@rosinsautofab1956
11 ай бұрын
Ya 14b front and rear, I have some build content on it, Reid gm 60 outers with branik 40 spline goodies, 2 piece front shaft has lots of clearance
@seanhernandez5208
11 ай бұрын
@@rosinsautofab1956 Thanks for the reply! I did watch the 3 part series’s, nice work. I was just curious because I ordered a 14 bolt front axle with the exact specs as a GM dana 60. My inner Cs are Solid industries (not welded yet) and I have been thinking of adding the super C king pin inner C and knuckle. What size ujoint are you using with your 40 spline shafts?
@rosinsautofab1956
11 ай бұрын
1480 branik 300m legacy u joints, if I did it again I would do super c and 47 spline rcv, I should be good with the 40 spline stuff, rcv 40 spline shafts neck down to the same size as there 35spl shafts so I decided against rcv and went with branik
Пікірлер: 4