Bravo! I'm a Master Electrician with more than 35 years in the field and you did a fine job
@chong210
12 жыл бұрын
nice video sir now i know whats best for me!
@sparkyjohnrg
12 жыл бұрын
Thanks for your kind words!
@MrJfon78
12 жыл бұрын
Thanks great video
@1977martincho
10 жыл бұрын
I had 31.5 in to the ceiling and i subtracted 6 in and i did my 90 degree bend and was good, then i had to go to a 55 in wall and make another 90 degree bend horizontal to the right, i measured the 55 in and i subtracted the 6 in again but my bend was like 7 in back from it was supposed to be. how should i do it next time. all the videos that i have seen are like back to back 90 degrees but what about if i have to make 3 90 degrees bending in different directions all of them? could you help me please.
@carlsails58
11 жыл бұрын
Great. Thanks.
@sparkyjohnrg
12 жыл бұрын
Thanks!
@rockbase1
10 жыл бұрын
I am having a grip of trouble.. i need to figure out how to bend a conduit tube to a 6 inch radius...if you can please help?
@JohnRGrau
10 жыл бұрын
What trade size conduit?
@rockbase1
10 жыл бұрын
aircraft rib....1/2 inch o.d.
@JohnRGrau
10 жыл бұрын
Rockbase Masonry I am no expert on aircraft rib, or what it even is. You might want to try a metal fabrication shop.
@1977martincho
10 жыл бұрын
it was 3/4 emt
@ktsaved
10 жыл бұрын
Subraect 5" from what?
@sparkyjohnrg
10 жыл бұрын
Subtract 5" from the desired length, place the bender's arrow at that mark (with handle pointed towards the end you measured from), and bend the pipe. It adds 5" during bending.
Пікірлер: 15