Connecting your Ruida-powered laser to Lightburn over Ethernet is easier than you think. It takes just a few minutes, and you'll be up and running in no time at all.
Windows command: ipconfig
macOS command: ifconfig
You're looking for the IP address of the Ethernet port as well as the subnet mask/gateway, both of which are required to connect your laser to Lightburn. Take the IP address, offset it by one (I went from .39 to .40), and enter that address (and the exact subnet mask) into the laser. In Lightburn, simply enter the IP address you put into the laser, and you'll be ready to go!
~~~~~~~~~~~~~~~~Chapters~~~~~~~~~~~~~~~~
00:00 - Intro
00:49 - Getting the IP in Windows
01:22 - Entering the IP and subnet into the laser
02:22 - Configuring Lightburn
02:56 - Outro
~~~~~~~~~~~~~~~~Links~~~~~~~~~~~~~~~~
Use code CREATEDWORKSHOP for 10% off at Monport
Monport 80W CO2 Laser Engraver - bit.ly/3N7wLK2
Calipers - amzn.to/3NHnsQ2
Exhaust fan kit - amzn.to/3GKa8rH
6-inch Duct Hose amzn.to/3XSv9Xu
Lightburn - lightburnsoftware.com/
Creative Fabrica - bit.ly/3WYs2gW
~~~~~~~~~~~~~~~~Camera gear~~~~~~~~~~~~~~~~
Body: Sony a6500 amzn.to/3UbILMd
Body 2: Sony a6000 amzn.to/3UyW1Kj
Main lens: Sony 18-105mm f/4 amzn.to/3fIxjZp
Secondary lens: Tamron 28-75 f/2.8 amzn.to/3FOVOi2
~~~~~~~~~~~~~~~~Store~~~~~~~~~~~~~~~~
Check out my store to support Created Workshop! createdworkshop.com
~~~~~~~~~~~~~~~~Social links~~~~~~~~~~~~~~~~
Be sure to follow me across social media to stay up-to-date on the latest projects at Created Workshop!
/ createdworkshop
tiktok.com/createdworkshop
/ createdworkshop
~~~~~~~~~~~~~~~~Affiliate disclosure~~~~~~~~~~~~~~~~
Some of the links above are affiliate links and Created Workshop could earn a small percentage of revenue from your purchase through them. There is no additional charge for you to use these links, but it does go a long way to support our content.
Негізгі бет Тәжірибелік нұсқаулар және стиль Connecting to your laser with Lightburn over Ethernet - Easier than you think
Пікірлер: 9