Tired of having to hold open your hood with one hand while you wrestle with a hood prop to keep it open? In this video I show you how quick, easy, and inexpensive it is to convert your hood from manual to automatic opening using hydraulic lifts. I used a 5/16" x 18 thread tap to cut a threaded hole for my ball studs to screw into, but you can also just drill a hole and secure with a washer and nut (included with the ball studs!).
I did this on my Dodge Charger but it would work with any vehicle.
hood lift support: amzn.to/2unmIHT
10mm ball studs: amzn.to/2ul6m2z
ball studs with brackets: amzn.to/2ujawrR
tap and die set inexpensive: amzn.to/2Yfhax5
tap and die set expensive: amzn.to/2TkOkrf
#wjhandydad #dodgecharger #hoodlifts #DIY
www.WJHandyDad.com
Disclaimer:
Due to factors beyond the control of WJ Handy Dad, I cannot guarantee against improper use or unauthorized modifications of this information. WJ Handy Dad assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. WJ Handy Dad recommends safe practices when working on vehicles/homes and or with tools seen or implied in this video. Due to factors beyond the control of WJ Handy Dad, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not WJ Handy Dad.
As an Amazon Associate I earn from qualifying purchases
Негізгі бет Convert Your Hood to Automatically Open with Hydraulic Hood Lift Supports
Пікірлер: 16