Very helpful......My OLED blinked once, showed my pattern. Then a wire to arduino RESET pin made it stay working.
@howardtomlinson3871
Жыл бұрын
I was getting frustrated watching you do the soldering until I tried it myself. Those connections and that smd resistor are SO tiny, you did a great job 👍👍
@MonidethPen
3 жыл бұрын
Very nice and clear instructions! Those 2.42" OLED screens require a power on reset (just like on an Amiga), and the reset pin on Gotek board provides exactly that (as well as being for manual reset).
@retrofriends
3 жыл бұрын
Thanks!
@MobCat_
3 жыл бұрын
Thank you, the clone of this screen had the resistors set for SPI but not the jumpers, adding the shorts to R15 and R13 in my case fixed my screen. When using with an ESP32 you also have to connect the RES pin to the ESP32 reset line, in the case of the dev board I have it's labeled as EN. Not 100% sure of this but I believe the CS pin is for chip select, so you can have 2 or more screens running on the same SPI Line, then you short to GND the CS line of the screen you want to use, then reset the screen and now you can use it. This may not work with some microcontrollers and is more of an educated guess..
@fernandolobinho3301
2 жыл бұрын
Thank you for this intuitive video I managed to put working all my displays. Great
@JimCoupeTQ
3 жыл бұрын
MAn thanks alot.. this was super informative.. i needed it so badly
@DesImaxina
3 жыл бұрын
VCC -- 10K -- Reset-- | 100nF | -- GND and no reset connection external is necessary
@randomXsearcher
3 жыл бұрын
Thank you for confirming no external reset.
@xn00dlesx
3 жыл бұрын
Thank you! This was mentioned nowhere else. Works great with the SSD1306 driver and pydPiper now.
@aranavia4787
5 ай бұрын
27K and 10uF in my case were helpful
@HeyApos
Жыл бұрын
Thanks very much. Really saved my life :-)
@tinker7722
3 жыл бұрын
Thank you! That helps a lot!
@mindenhato5601
2 жыл бұрын
Awesome thank you werry much :D
@Wallygjs
3 жыл бұрын
Thanks again, highly instructive video.
@retrofriends
3 жыл бұрын
You are welcome :)
@amishpatel623
3 жыл бұрын
Where do i put the rst pin for a Raspberry Pi 3, and can I put a 0 Ohm resistor for r3. Also do I need to short R7 to CS for my Raspberry pi 3?
@360Sebastian360
2 жыл бұрын
Do you power your 2.42 inch OLED via 3.3 or 5 volt ?
Пікірлер: 20