Thought I would try to lay up decals straight into the mould.. And results were amazing 😍
@skogzor
5 ай бұрын
What happens instead if you stick the sticker to the mould?
@CarbonWorkshops
5 ай бұрын
@@skogzor maybe work 🤷 I imagine sticking it on fresh release agent wouldn't be very tricky.
@soimu_0731
5 ай бұрын
2:27 -> weave directions same as previous layer (still 0-90° ↑→). You'd have to cut the material with the +/-45° in mind ↘↗ (you'll maybe have more scraps leftovers ). I see that EC don't have Biaxial in prepegs...only Unis. Keep it up 👍, can't wait to upgrade to prepegs. Regarding the sticker, are you not concerned about color fading ?
@johnmichaels4330
5 ай бұрын
What are you making in these videos? Is it a plate of some sort?
@bradr539
5 ай бұрын
@@johnmichaels4330Fuel tank cover..
@MR-Trabi1963
Күн бұрын
Pls show us the KTM, I swear every video is a ktm part WE NEED TO SEE THE KTM this is very handy as I want to start a store like this in the future But need the funding lol
@sekaf4125
Ай бұрын
so doe the heat activate the impregnated carbon to harden?
@alejandroramaverdes6735
5 ай бұрын
Which is the best form to create an interior details for an Audi A5 (dors, central and front console), create moulds or cover original pieces?? I like you job and pieces a lot
@CarbonWorkshops
5 ай бұрын
Interior pieces that have lots of clips to hold in place are often easier to cover over the part.
@alejandroramaverdes6735
5 ай бұрын
@@CarbonWorkshops By applying a thin layer of carbon to the pieces there should be no problem with fitting in their original position, right?
@911marcus
5 ай бұрын
wow, nice work 😍
@kohlersven-eric8006
4 ай бұрын
Are those stickers made from a heat resistant material?
@CarbonWorkshops
4 ай бұрын
No, just standard vinyl
@teoyota
5 ай бұрын
Why did you not just clear the mold and save the extra work?
@CarbonWorkshops
5 ай бұрын
From experience, this won't work with prepreg carbon fibre.
@teoyota
5 ай бұрын
But it works works fine with infusion?
@CarbonWorkshops
5 ай бұрын
@@teoyota prepreg is different, if you stick the carbon and need to adjust it will pull the clear coat from the mould. Also I don't think it will handle 120 deg celius
@autovmcomposites9997
5 ай бұрын
there are special in mould coatings used in the industry. But expensive and the moulds have to be 100% flawless and ultra high goss, otherwise you never would get a finish like the end result in this video
@TrueRewire
5 ай бұрын
Why ruin the bag? Couldn't you have re-used it?
@CarbonWorkshops
5 ай бұрын
Single use, they melt together and heat makes them brittle
@Carton-f4l
5 ай бұрын
Bro super informative video🎥 How to calculate strength
Пікірлер: 24