I like your video. You are the only KZitem video on this that says you need to fill bottom reservoir when putting in new surge tank. Others just installed and filled the top of the surge tank.
@crashdsnowman1
6 күн бұрын
Quick fix is make a jumper across the sensor plug. The lower part of the tank is an overflow res only it should not be full.
@reidjohnson6296
7 ай бұрын
The book says the lower section should be close to empty when it's cold. The top part starts out full and expands into the bottom section as it heats up. The sensor is just shot. Doesn't the sensor just come up through the bottom side of the top tank?
@SmokeysBoy
Жыл бұрын
Thank you so much, doing it myself saved nearly $500.00!
@showmemechanics
Жыл бұрын
No problem, thanks for watching.
@donovankaufman9232
2 ай бұрын
How much should this cost? Also how long it take for a 1500
@franciscolara438
Жыл бұрын
Thank you so much for that information
@showmemechanics
Жыл бұрын
No problem, thanks for watching.
@abramweston9873
Жыл бұрын
Doesn’t the coolant in pressurized side fill during the proper fill process as the thermostat opens? Serious question because I’m replacing my coolant reservoir tomorrow because of a leak I thought was the radiator I replaced. It’s got to be the reservoir or the water pump from what I’ve read.
@showmemechanics
Жыл бұрын
No, you will have to fill each tank individually. The lower tank has the low coolant sensor in it.
@mitchellsmith216
Жыл бұрын
Do I have to open up that bottom cap to pour in through the tiny hole?
@showmemechanics
Жыл бұрын
Yes I remove the lower cap and pour it through the tiny hole under the upper cap till it comes out the bottom, then put the caps back on. It's a pain.
@mitchellsmith216
Жыл бұрын
Awesome, thanks!
@tunamanusmc
7 ай бұрын
You don’t have to fill the bottom tank that’s the overflow tank 🤦. The sensor is on the top section of the tank
@showmemechanics
7 ай бұрын
That's the tank where the sensor is located, that's why it has 2 caps. If you don't fill it it will always read low coolant
@crashdsnowman1
6 күн бұрын
@@showmemechanics Look close at the new clear tank in your video, the sensor points up and the float is in the top half of the tank.
Пікірлер: 17