1st setup of the new cross gantry from CoreXYI converted the top section from CoreXY to Crossed Gantry to see if performs better.This is 500mms @ 55K acceleration up and down, no skipped steps.
300x300 build volume.
I am using 2 .59Nm motors and 2 .43Nm. I need to add 2 more .59's, getting there.Previous speed and accel was 500mms@ 45K with no skipped steps. Slight increase, but not quite there with alignment.
Very rigid toolhead!
Негізгі бет CoreXY to Crossed Gantry
Пікірлер: 35