I'm mostly into imports but I can appreciate the hard work and dedication to the build. I would definitely give this a nod. Cheers.
@AADmrstangerbanger
5 ай бұрын
Thanks, I love all Cars but foxbody was my first car so love em
@JasonsFourCamFox
5 ай бұрын
I'm doing a Coyote Fox too and noticed you left the stock front sway bar mounts in place and were able to install through the bottom? I've heard this cannot be done, but clearly, you did it. Can you give me any pointers on how to go about installing mine the same way? I bought the lift pieces to install through the top, but I really don't want to go that route... :/ Thank you and thanks for the video!
@AADmrstangerbanger
5 ай бұрын
So you have to trim a little off each sway bar mount and motor will fit. So I would highly recommend installing motor from the bottom like I did. I think I talk about how I installed mine and what I used in one of the videos I think if not I can make a video and go over it. Either way you can install motor from top but I would get K member and headers then go from bottom and pick up car with cherry picker from core support.
@JasonsFourCamFox
5 ай бұрын
@@AADmrstangerbanger thank you, I appreciate it! How much do I trim off the mounts? I watched all of your Coyote Fox videos today and didn't see that part explained, but you did give me info on some little stuff I didn't have, like the TechFlex loom, the power distribution block and positive wire size! I was lucky enough to have this video on my KZitem homepage feed this morning! I actually have some 5000lb Quick Jacks, that should get the car up 24" and if I need more room, I can figure it out from there. I too am doing my swap correctly, I have Maximum Motorsports everything underneath my 88 Coupe and I've ordered everything else, including a new crate Gen 3 Coyote from PBH, as well as a new TKX from Modern Drive Line! I, like yourself, understand the importance of doing things the right way! My engine should be on the way here in a couple of weeks?
@AADmrstangerbanger
5 ай бұрын
@@JasonsFourCamFox So all your going to do is take a grinder and or cut off wheel and take about half inch off each side. All make a video today explaining more k
@JasonsFourCamFox
5 ай бұрын
@@AADmrstangerbanger Cool, I'll do that this weekend!
Пікірлер: 7