Nice was always wondering how you balance a crankshaft. Very informative, Thanks :)
@dewragg4pet
11 жыл бұрын
you maybe " down under " but your video's are top shelf ! thanks and keep them coming :)
@PooManchoo2
7 жыл бұрын
You say you do the crank on it's own and not with the front balancer or fly/flex, but that's assuming internally balanced, yes? What about external balanced where the balancer and fly/flex also have bobweights? I would expect that they'd need to be fitted and balanced as one assembly throughout the entire procedure. Good videos and insight, by the way. Thanks for posting.
@UniqueZed
7 жыл бұрын
You can balance altogether or neutrally balance the crank pulley, clutch and flywheel by themselves.
@PooManchoo2
7 жыл бұрын
Thanks. So I dare say that with externally balanced is that you'd NEED to? ie: BBC 454
@s.v.gadder1443
7 жыл бұрын
No!!!!! 4 cylinders aren't the same as v8s they have 2 cylinders knee direction and the other 2 180deg opposite so you balance the crank alone then weight match the pistons and rods and the rest is a neutral balance, v8s are not this way except the new 5.0 cyote engines ford made they are designed just like a 4 banger 4 pistons 180deg opposed by 4 more which allows you to balance the crank alone then balance the parts separate regular v8s have to have bob weights attached to simulate the weight of the pistons and rods regardless of. Whether or not it's neutral balanced
@the178x
10 жыл бұрын
Thank you so I can send someone the right process. Mr joe
@s.v.gadder1443
7 жыл бұрын
I've seen several cranks that broke thecounter weights bc they installed the Mallory the way you just said I 100%believe that installing it the same way the holes are drilled is 100000000x safer as long add its welded its not possible to just fly out like you mentioned the whole damn crank would fly apart first smdh that practice of side ways install is dangerous and if it's small amounts it's way better to remove material from the pistons which is the right way it just takes more time and skill so most shops have resorted to quick and easy instead of theRight correct and safe way
@jalaludinpuku3384
5 жыл бұрын
Di indonesia yg bisa ngebalance seperti ini dimna ya
@snickerdoodle1361
7 жыл бұрын
What I could hear was like a question in every sentence!
@sandapyaesone
9 жыл бұрын
Is there somebody explain me the term "TDC" that express at the machine? Left | TDC | Right . . . What TDC stands for?
@sandapyaesone
9 жыл бұрын
Bobert Bongmong And Left and Right Means?
@Impetuss
7 жыл бұрын
Top dead center i think, left and right side of the crank
@s.v.gadder1443
7 жыл бұрын
Yrs left top dead center and right to dead center so you know where to add or remove weight
@Craig1337GT
12 жыл бұрын
watch part one mate.
@sh3lbot
8 жыл бұрын
I paid a machine shop to balance my whole rotating assembly and I know for sure they didn't do a good job like this.
Пікірлер: 19