Updating the Creality Ender 3 S1 Firmware from v3.0.4 to 3.1.9 or 3.2.0.
Tools needed:
2.5mm Allen Key to open the back of the screen.
1 SD Card.
1 Micro SD Card.
Both cards formatted to FAT32 with 4096bytes Allocation Unit (MUST).
Firmware files from Creality's website.
Note:
You will need 32GB or under SD, and Micro SD, card to format for FAT32. FAT32 is not supported on SD/Micro SD Cards over 32GB capacity, unless you use some special software for it.
Негізгі бет Creality Ender 3 S1 3D Printer Firmware Update
Пікірлер: 39