Hi im from New Zealand and this video worked well as i just followed the NZ geometric design manual
@kevinjackman3123
2 жыл бұрын
Hi Kyle - great video. Any chance you could share your edited XML file? I am doing some work for A.T. at the moment and am hoping to not reinvent the wheel!
@kostadinpapanov
11 ай бұрын
Hello, Very helpfull video. I have one question about superelevation error which is caused by by rate of change what should be under 0.06(which makes very long runoff). There is a solution in Autodesk forum, but it disables all design checks.
@KyleEvansCivil
11 ай бұрын
You would need to edit the design criteria editor file for that as well. We used to have an 8% max, lowered to 6. All of it should be able to get setup in the editor.
Пікірлер: 4