Good video, but stresses are not calculated in the elemend nodes. Only displacements are. After the initial calculation of the displacement, the stresses are calculated in the Gaussian points in the element. So the stresses on the nodes are interpolated from the gaussian points
@nothingbutengineering
15 күн бұрын
Thanks for additional information.
@XRONX-1
6 ай бұрын
Thanx why we choose constraints like is it a reference that which going to be fixed or during load which going to be get affected?
@nothingbutengineering
6 ай бұрын
We fix mounting locations because those are gonna stay immovable relative to the rest of your body. Like nails in a door hinge. For complicated assemblies, we rigidly link bolted joints and fix ground locations (where it is connected to immovable structure or grounded to Earth simply)
@amanrizvi8808
Жыл бұрын
Great, do u provide private lessons!?
@elohell7876
2 ай бұрын
Subbed
@santoshbiradar7395
4 ай бұрын
I want to lift a 1tonne weight through eye bolt in this case how I want to find stress developed near the trheaded hole. How to do this
@nothingbutengineering
4 ай бұрын
In this case you need to perform a bolted joint analysis. Perform the FEA using idealised rigid link and extract forces from all three axes. Input those values in an online bolted joint calculator to see if its sufficient.
@bhooshan25
10 ай бұрын
Which GPU do you recommentd for creo simulate?
@adhithasimhanraghavan7516
8 ай бұрын
If you are looking for professional use, go for Quadro with minimum 4GB video ram. For hobbyists, it would work as low as Gtx 710
@nothingbutengineering
6 ай бұрын
Yes
@rayz9860
7 ай бұрын
In cracked version of Creo,I’m not able to use simulate options
Пікірлер: 17