pronounced /krōt′n/.....not a bad entry entry level watch along with citizen and bulova. Since it has an exhibition back, a Bergon 8 Ball would have probably worked a bit better. As you said, that wrench was made for Rolex backs which have a finer notch spacing. This probably retailed for 400-600 just because of the ETA movement.
@JT_Trades_Treasure
5 ай бұрын
Thanks for the pronunciation. I have seen the balls used for case backs before. I will probably grab one of those soon, too. The teeth and the wrench were off for sure. The movement is the most interesting part! I have never had a 2671 before and I am amazed how much ETA could cram in a small space!
@crli4353
5 ай бұрын
@@JT_Trades_Treasure What kind of camera set up do you have? Do you have your camera on a boom?
@JT_Trades_Treasure
5 ай бұрын
@@crli4353 I think so. I use a Sony A6000 with a 30mm F3.5 prime lens that is a macro. I have it attached to a desk clamped heavy duty microphone arm. I have a professional boom stand with a counter weight but adjusting the camera would be a pain on it. I want a zoom macro lens but as far as I know Sony camera systems don't have one.
@crli4353
5 ай бұрын
@@JT_Trades_Treasure Ah, so your bench must sit kind of low where you can see the screen on the back of the camera. Jewelers benches sit about 36" high so I ned to set up a lower table for vids....thx
@JT_Trades_Treasure
5 ай бұрын
@@crli4353 One of the reasons I can never find any tools is because the table I use is the same table I use for my studio work. I don't have a designated place for each, unfortunately. I think my desk is about 24" from the ground and I am sitting down when doing videos. When I take photos for my eBay store I am standing. Hope that helps.
Пікірлер: 6